Ariens 891008 - ROPS UNIT INSTALLATION

EN - 14
(ROPS Units Only)
See Figure 16.
1. Install hex bolt (Item 10) into the right
rollover protection structure (ROPS)
bracket with a spin lock flange nut (Item
12) in the center of the bracket.
2. Secure hex bolt with a flat steel washer
(Item 13), spacer (Item 11) and top lock
flange nut (Item 9).
3. Repeat steps 1 – 2 on left ROPS bracket.
Bagger Supports
See Figure 17.
1. Install hex bolt (Item 10) into the right
bagger support with a spin lock flange nut
(Item 12) in the center of the bracket.
2. Secure hex bolt with a flat steel washer
(Item 13), spacer (Item 11) and top lock
flange nut (Item 9).
3. Repeat steps 1 – 2 on left bagger
support.
4. Install left bagger arm (Item 4) onto
bagger post (Item 2) with two hex bolts
(Item 18) and two top-lock flange nuts
(Item 9). Do not tighten. Repeat on right
bagger arm (Item 3). See Figure 18.
Figure 16
10
13
11
12
9
Figure 17
10
12
13
11
9
Figure 18
3
9
4
18
2