Ariens 921047 User Manual (English)

Other manuals for Ariens 921047

Operator's Manual30 pages

Service Manual76 pages

Questions and Answers:

J
Jesse WilliamsAug 15, 2025
What to do if Ariens 921047 Snow Blower doesn't throw snow?
- M
  Michelle AyalaAug 15, 2025
  If your Ariens Snow Blower isn't throwing snow or throws it poorly, several factors could be at play. Ice or debris might be obstructing the auger; stop the engine, remove the key, wait for moving parts to stop, and remove the obstruction before restarting. The discharge chute may be clogged with snow; stop the engine, remove the key, wait for all moving parts to stop and for hot parts to cool, then clean the discharge chute and auger housing with a clean-out tool. The impeller could be frozen in place; move the unit to a warm place to thaw it. Other potential issues include broken shear bolts or an incorrectly adjusted attachment clutch/brake.
R
Randall WeaverAug 18, 2025
Why won't my Ariens Snow Blower move forward or backward?
- V
  vbaileyAug 18, 2025
  If your Ariens Snow Blower isn't driving forward or in reverse, the friction disc may be worn and need replacement. The traction drive cable might not be adjusted correctly; remove slack from the cable. Alternatively, the traction belt may not be functioning correctly and require repair or replacement. Lastly, the speed selector might not be adjusted correctly; adjust the speed selector.
L
linlisaAug 21, 2025
Why is my Ariens 921047 Snow Blower belt squealing?
- R
  Ryan CollierAug 21, 2025
  A continuous belt squeal in your Ariens Snow Blower could be due to a couple of reasons. The impeller might be frozen, so move the unit to a warm area to thaw it. Alternatively, the attachment clutch may need adjustment.
O
oyoungAug 25, 2025
Why does my Ariens Snow Blower engine keep stopping?
- J
  Jamie HoltAug 26, 2025
  Your Ariens Snow Blower engine might be stopping due to several reasons. The fuel tank could be empty, so refill it. The fuel valve might be closed, so open it. There might be an obstruction in the auger or impeller; if so, stop the engine, remove the key, wait for all moving parts to stop, and then remove the obstruction before restarting. Alternatively, the fuel supply could be contaminated, so replace it with clean fuel. The spark plug might be faulty, so replace or clean it. Lastly, the fuel cap vent could be blocked, so install a new fuel cap.
J
Justin Knapp DDSAug 28, 2025
Why does my Ariens 921047 Snow Blower start hard?
- M
  Michael GregoryAug 29, 2025
  If your Ariens Snow Blower starts hard or runs poorly, the fuel mixture might be too rich; turn the choke control knob to the off position. Also, the spark plug may be faulty, fouled, or incorrectly gapped; clean and correctly set the spark plug gap, or seek assistance from your Ariens dealer. Finally, the fuel cap vent could be blocked; install a new fuel cap to resolve this issue.
J
Jeffrey KaneSep 1, 2025
Why does my Ariens 921047 Snow Blower run briefly then stop?
- J
  Joshua WilsonSep 1, 2025
  If your Ariens Snow Blower runs briefly and then stops, it could be due to a build-up of fumes in the fuel tank creating too much pressure. Try slowly loosening the fuel tank cap to relieve the pressure.
G
gbushSep 4, 2025
Why does my Ariens 921047 pull to one side?
- W
  wjohnsonSep 4, 2025
  If your Ariens Snow Blower pulls to the left or right, it may be because the skid shoes and scraper blade need adjustment. Adjust both the skid shoes and the scraper blade.
C
Cynthia WilliamsSep 7, 2025
What causes an Ariens 921047 Snow Blower to leave too much snow behind?
- B
  Brian WilliamsSep 7, 2025
  If your Ariens Snow Blower is leaving excessive snow behind, the scraper blade may be worn or damaged. Adjust the scraper blade when worn, and replace it when damaged or when it has been adjusted down as far as possible and does not touch the ground or clear correctly.
S
stephaniemitchellSep 12, 2025
Why are there rubber beads collecting in the frame of my Ariens 921047?
- J
  Joanna JacksonSep 12, 2025
  The collection of small rubber beads in the frame of your Ariens Snow Blower is usually normal friction disc wear. No correction is needed unless there are chunks or large pieces of rubber collecting in the frame.

Ariens 921047 Specifications

General

Clearing Width	24 inches
Drive Type	Wheel drive
Speeds	6 forward, 2 reverse
Auger Material	Steel
Skid Shoes	Adjustable
Intake Height	21 inches
Speed	6 forward, 2 reverse
Starting System	Recoil
Tire Size	13 inches
Weight	247 lbs
Starter	Electric/Recoil