4
For your safety
ALWAYS ● When the dryer is not in use, switch off and close the door.
ALWAYS ● Comply with the specified electrical requirements.
ALWAYS ● Ensure that your dryer is installed correctly and has adequate
ventilation. (see, "Installation Instructions")
ALWAYS ● Finish every programme with the cool tumble cycle provided.
ALWAYS ● Clean the filter, it is essential that the filter is kept clear of lint at all
times.
ALWAYS ● Observe the rules for drying garments.
Grounding Instructions
In the event of malfunction or breakdown, grounding will reduce the
risk of electric shock by providing a path of least resistance for electric
current. This appliance is equipped with a cord having an equipment-
grounding conductor and a grounding plug. The plug must be plugged
into an appropriate outlet that is properly installed and grounded in
accordance with all local codes and ordinances.
DO NOT modify the plug provided with the appliance. If it will not fit
the outlet, have a proper outlet installed by a qualified electrician or
exchange the cord with an appropriate one rated for the dryer.
REFER TO THE RATING PLATE FOR VOLTAGE AND CURRENT
REQUIREMENTS (see diagram for location.)
The dryer should be connected to the power source via a suitable
socket which is accessible after installing your dryer.
This dryer must be connected to 30A INDIVIDUAL BRANCH
CIRCUIT.
For full details see ‘Installation Instructions’ section of this book.
WARNING:
THIS APPLIANCE MUST BE GROUNDED.
Improper connection of the equipment-grounding conductor
can result in a risk of electric shock. Check with a qualified
electrician or service representative or personnel if you are
in doubt as to whether the appliance is properly grounded!
NOTE: IF IN DOUBT ABOUT ANY OF THE ABOVE CONSULT
A QUALIFIED ELECTRICIAN.
CAUTION:
Avoid touching the rear of the dryer when it is
in use, as it may be hot!
To Next Page
Loading...
Need help?
General