Ariston AQUALTIS AQ82F 29 - Wash Cycles and Options; Table of Wash Cycles; Wash Options

AUS
9
Wash options
! If the selected option is not compatible with the selected
wash cycle, this incompatibility will be signalled by the
flashing of the indicator light and a sound alert (3 beeps);
the option will not be activated.
! If the selected option is not compatible with another option that
has been selected previously, the indicator light corresponding
to the first option selected will flash and only the second option
will be activated; the indicator light corresponding to the button
will remain lit in a constant manner.
Extra rinse
By selecting this option, the efficiency of the rinse is increased
and optimal residual detergent removal is guaranteed. It is
particularly useful for skin which is sensitive to detergents. We
recommend this option is used with a full load of washing, or
when a large amount of detergent is required.
Easy Iron
By selecting this option, the wash and spin cycles will be
modified in order to reduce the formation of creases.
At the end of the cycle the washing machine drum will
rotate slowly; the “Easy Iron” and START/PAUSE indicator
lights will flash. To end the cycle press the START/PAUSE
button or the “Easy Iron” button.
Super Wash
This option offers a high-
performance wash due to the
greater quantity of water used
in the initial phase of the cycle,
and due to the increased wash
cycle duration, is particularly
useful for the removal of
stubborn stains. It can be used
with or without bleach. If you
desire bleaching, insert the
extra tray compartment (3) into
compartment 1. When pouring
in the bleach, be careful not to exceed the “max” level marked
on the central pivot (see figure). To bleach laundry without
carrying out a full wash cycle, pour the bleach into the extra
compartment 3, select the “Rinse” cycle” and activate the
“Super Wash” option .
Prewash
If this function is selected, the pre-wash cycle will run; this is
useful for removing stubborn stains.
N.B.: put the detergent in the relevant compartment.
3
1
2
Wash cycles and options
Table of wash cycles
Icon
Description of the wash cycle
Max.
temp. (°C)
Max.
speed
(rpm)
Detergent and additives
Max. load (kg)
Cycle dura-
tion
Prewash
Wash
Bleach
Fabric
softener
Synthetics
60° 800
   
4,5
Whites
60° 1200
 
-

5
Coloureds
40° 1200
   
5
Darks
30° 800 -

-

5
Shirts
40° 600 -
  
2
Duvets: for down-stuffed garments. 30° 1000 -

-

3,5
Bed & Bath for bedlinen and towels. 60° 1200
   
8
Rinse
- 1200 - -
 
8
Spin and Pump out - 1200 - - - - 8
Anti Allergy
60° 1200 -

-

5
Ultra Delicates
30° 0 -

-

1
Wool: for wool, cashmere, etc. 40° 800 -

-

2
Mix 30': to refresh lightly soiled garments quickly (not suitable for wool, silk
and clothes which require washing by hand).
30° 800 -

-

3,5
Cotton Standard 60°C: heavily soiled whites and resistant colours.
60°
(Max. 90°)
1200
(2)
  
8
Cotton Standard 40°C (1): lightly soiled whites and delicate colours. 40° 1200 -
  
8
Cotton Standard 20°C: lightly soiled whites and delicate colours. 20° 1200 -
  
8
(*) The duration of the wash cycles can be checked on
the display.
(*) Note: 10 minutes after the START, the machine will recalculate the time remaining until the end of the wash cycle on the basis of the
load inside it; this value will then be shown on the display.
The length of cycle shown on the display or in this booklet is an estimation only and is calculated assuming standard working conditions. The actual duration can vary according to factors such as
water temperature and pressure, the amount of detergent used, the amount and type of load inserted, load balancing and any wash options selected.
2) At 60 °C the “Prewash” function cannot be selected.
For all Test Institutes:
1) Test wash cycle in compliance with regulation AS/NZS 2040.2: set wash Program Cotton Standard with a temperature of 40°C
at 1200 rpm and using a load of 8 kg.