19504265000 English. {PDF Created 13/11/04 11:53}
4
Start and Programmes TD4049 Issue 2
Choosing a Programme
1. Plug the dryer into the electrical socket.
2. Sort your laundry according to fabric type (see
Laundry).
3. Open the door and make sure the filter is clean and
in place and the water container is empty and in place
(see Maintenance).
4. Load the machine and make sure that the items are
not in the way of the door seal. Close the door.
5. If the On/Off light is not lit; press the On/Off Button
6. Choose a programme by checking the Programmes
guide (see Programmes) as well as the indications for
each type of fabric (see Laundry).; - select a programme
by rotating the PROGRAMME knob.
7. Set a delay time and other options if necessary.
8. If you wish the buzzer to sound at the end of the
programme, press the ALARM Option button.
9. Press the START button to begin. During the drying
programme, you can check on your laundry and take
out the items that are dry while the others continue
drying. When you close the door again, press START in
order to resume drying
10. During the last few minutes of Drying Programmes
before the programme is completed, the final COOL
TUMBLE phase is entered (fabrics are cooled), this
phase should always be allowed to complete.
11.When the programme is complete.
The buzzer will sound if the Alarm option was selected.
Open the door, take your laundry out, clean the filter
and replace it. Empty the water container
and replace
it
(see Maintenance).
If the Post Creasecare option has been selected and you
do not take the clothes out immediately the clothes will
tumble occasionally for 10 hours or until you open the
door.
12. Unplug the dryer.
Easy Iron Programme
Easy Iron is a short 10 minute programme (8 minutes of heat followed by a 2 minute cool tumble period) which fluffs the
fibres of clothing that has been left in the same position/location for an extended period of time. The cycle relaxes the fibres
and makes them easier to iron and fold.
!
Easy Iron is not a drying programme and should not be used for wet articles of clothing.
For best results:
1. Do not load more than maximum capacity. These numbers refer to dry weight:
Fabric: Max load:
Cotton and Cotton mix 2.5 kg
Synthetics 2 kg
Denim 2 kg
2. Unload the dryer immediately after the end of the drying cycle, hang, fold or iron the articles and put them away in the
closet. Should this not be possible, repeat the cycle.
The Easy Iron effect varies from one fabric to the next. It works very well on traditional fabrics like Cotton or Cotton mix,
and less well on acrylic fibres and on materials such as Tencel.®
GB
To Next Page
Loading...
Need help?
General