Ariston Chef Plus MWA 25 B - Basic Operation Modes; Stand-by Mode and Child Lock; Pausing and Managing Cooking; Clock Settings

Depending on the selected function, it could be
needed to add / stir / turn food during cooking. In
these cases the oven will pause cooking and it
will ask you to perform the needed action. When
required, you should:
ADD / STIR / TURN FOOD
START PROTECTION / CHILD LOCK
This automatic safety function is activated one
minute after the oven has returned to “Stand-by
mode”.
When the safety function is active the door must
be opened and closed in order to start the cook-
ing,
otherwise the display will show “door”.
PAUSE OR STOP COOKING
To pause cooking:
The cooking can be paused to check, turn or stir
the food by opening the door. The setting will be
maintained for 5 minutes.
To continue cooking:
Close the door and press the Jet Start button
ONCE. The cooking is resumed from where it
was paused.
If you don’t want to continue cooking you can:
Remove the food, close the door and press the
Stop button.
When the cooking is finished:
A beep will signal once a minute for 10 minutes
whenthecookingisnished.PresstheStopbut-
ton or open the door to cancel the signal.
i
STAND-BY MODE
The oven is in Stand-by mode when the clock is
displayed (or, if the clock has not been set, when
the display will show “:”).
DOOR
1. Open the door.
2. Add / Stir / Turn the food (depending on the
required action).
3. Close the door and restart by pressing the
Jet Start button.
•  If the door is not opened within 2 mi-
nutes since the request to Add food, the
oven will stop and it will go in Stand-by mode.
•  If the door is not opened within 2 minutes
since the request to Stir or Turn the food, the
oven will continue the cooking process (in this
casethenalresults maynotbetheoptimal
ones).
CLOCK
•If the clock has not been set after plug in,
the clock will shows “12:00”.
•During the setting of the clock, if you press the
Stop button or if the setting is not completed after
a long time, the oven will exit from setting mode
and the setting will be invalid, display will shows “:”.
To set the Clock of your appliance:
1. Press the Clock button.
2. Press the Plus/Minus buttons to set the
hours.
3. Press the OK/Jet Start. The minutes will start
blinking.
4. Press the Plus/Minus buttons to set the min-
utes.
5. Press the OK/Jet Start button.The clock is
set.
Note:
The first time the appliance is plugged in (or after
a power failure), the prodct will automatically enter
the Clock Setting mode; in this case, please follow
the above procedure starting from step No.2.
77
en
hotpoint.co.uk