USER’S MANUAL
/ 4
This appliance is designed to produce hot water for domestic
use (combi version).
It should be connected to a heating system and a distribution
network for domestic hot water, both of which must be
compatible with its performance and power levels.
The use of the appliance for purposes other than those
specied is strictly forbidden. The manufacturer cannot be held
responsible for any damage caused by improper, incorrect and
unreasonable use of the appliance or by the failure to comply
with the instructions given in this manual.
Installation, maintenance and all other interventions must
be carried out in full conformity with the governing legal
regulations and the instructions provided by the manufacturer.
Incorrect installation can harm persons, animals and
possessions; the manufacturing company shall not be held
responsible for any damage caused as a result.
In the event of any maintenance or other structural work in the
immediate vicinity of the ducts or ue gas exhaust devices and
their accessories, switch the appliance off by switching the
external bipolar switch to the “OFF” position and shutting off
the gas valve.
When the work has been completed, ask a qualied technician
to check the efciency of the ducting and the devices.
If the boiler should be out of use for a prolonged period,
it is recommended that the electrical power supply be
disconnected and that the external gas cock be closed. If low
temperatures are expected, the boiler and system pipe work
should be drained in order to prevent frost damage.
Turn the boiler off and turn the external switch “OFF” to clean
the exterior parts of the appliance.
Do not allow children or inexperienced persons to use the
appliance without supervision.
Ariston is a licensed member of the
Benchmark Scheme which aims to
improve the standards of installation
and commissioning of domestic heating
and hot water systems in the UK and to
encourage regular servicing to optimise
safety, efciency and performance.
Benchmark is managed and promoted
by the Heating and Hotwater Industry
Council.
For more information visit
www.benchmark.org.uk.
The Benchmark commissioning checklist, which
can be found at the back of the installation
instructions, must be completed in full by the
installer and be left with the boiler or be made
available upon request by any attending Ariston
representative.
THE INSTALLATION AND FIRST IGNITION
OF THE BOILER MUST BE PERFORMED
BY QUALIFIED GAS SAFE REGISTERED
ENGINEER IN COMPLIANCE WITH
GAS SAFETY (INSTILLATION & USE)
REGULATIONS AND ALL OTHER NATIONAL
REGULATIONS REGARDING INSTALLATION,
AND IN CONFORMITY WITH ANY
REQUIREMENTS ESTABLISHED BY LOCAL
AUTHORITIES AND PUBLIC HEALTH
ORGANISATIONS.
AFTER THE BOILER HAS BEEN INSTALLED,
THE INSTALLER MUST ENSURE THAT THE
END USER RECEIVES THE DECLARATION
OF CONFORMITY AND THE OPERATING
MANUAL, AND SHOULD PROVIDE ALL
NECESSARY INFORMATION AS TO HOW
THE BOILER AND THE SAFETY DEVICES
SHOULD BE HANDLED.
UKCA labelling
The UKCA mark guarantee that the appliance conform to the
following UK regulations:
- Gas Appliances Regulation (Regulation (EU) 2016/426
as brought into GB law and amended) and the Gas
Appliances (Enforcement) and Miscellaneous Amendment
Regulations 2018 (S.I. 2018 No. 389, as amended)
- The Ecodesign for Energy-Related Products and Energy
Information (Amendment) (EU Exit) Regulations 2019 (S.I.
2019 No. 539, as amended)
- BED (Boiler Efciency Directive) - only art.7 ( 2), art.8 and
annex Ill, IV, V
- Electrical Equipment (Safety) Regulations 2016 (S.I. 2016 No
1101, as amended)
- Electromagnetic Compatibility Regulations 2016
- Radio Equipment Regulations 2017 (S.I. 2017 No. 1206, as
amended)
(S.I. 2016 No. 1091, as amended)
- The Restriction of the Use of Certain Hazardous Substances
in Electrical and Electronic Equipment Regulations 2012 (S.I.
2012 No. 3031, as amended).
CE labelling
The CE mark guarantees that the appliance conforms to the
following directives:
- 2016/426/EU relating to gas appliances
- 2014/30/EU relating to electromagnetic compatibility
- 92/42/CEE relating to energy efciency
- 2014/35/EU relating to electrical safety
- 2009/125/CE Energy related Products
- 813/2013 Commission regulation (EU)
- 2014/53/EU RED (Radio Equipment Directive)