Need help?Do you have a question about the Ariston TI PRO 15 OR 350 ID and is the answer not in the manual?
General| Capacity | 15 liters |
|---|---|
| Max. Working Pressure | 8 bar |
| Type | Electric Water Heater |
| Heating time (ΔT=45°C) | Approx. 45 minutes |
| Thermostat | Yes |
Connect water inlet and outlet with pipes or fittings resistant to pressure and temperature.
Use suitable watertaps for this installation type and follow scheme fig. 1A.
Connect the feeding cable to the thermostat terminals and ensure proper earthing.
Descale the heating element every two years and replace the magnesium anode.
Contact Technical Service if the thermal switch has interrupted the circuit due to overheating.
Check the safety valve function monthly and ensure it is not tampered with.
Turn on the appliance using the switch or control knob; red LED indicates heating.
Adjust water temperature by rotating the external knob connected to the thermostat.
Set the knob to the symbol for models equipped with this feature.
Connect inlet/outlet with resistant pipes; install 'T' union with tap and safety valve.
Use suitable watertaps and follow scheme fig. 1A; safety valve is not required.
Insert feeding cable, connect to thermostat terminals, ensure earthing and proper wiring.
Disconnect from mains, remove cover to access electrical parts or thermostat.
Descale heating element every two years, replace magnesium anode.
If thermal switch trips, call Technical Service to reactivate.
Check valve operation monthly; lift lever to empty if necessary.
Press switch or turn knob to start; red LED indicates heating.
Rotate external knob to increase or decrease setting temperature.
Set knob to symbol for models offering this function.
Connect pipes to water inlet/outlet; use T-union, tap, and safety valve.
Use suitable taps and follow scheme 1A; safety valve not needed.
Insert cable, connect to terminals, ensure earthing; follow wiring diagram.
Disconnect power, remove cover for access to electrical parts or thermostat.
Descale heating element every two years; replace magnesium anode.
Contact service if thermal switch trips due to overheating.
Check valve monthly; lift lever to empty if necessary.
Check heater is off and cool; flush valve with water to remove deposits.
To Next Page