Ariston AURES TOP 4.5P

Questions and Answers

J
Jason HarrisonAug 6, 2025
Why is my Ariston AURES TOP 4.5P not heating the water enough?
- R
  Robert HallAug 6, 2025
  If your Ariston Water Heater isn't heating water adequately, try these steps: First, increase the temperature or power setting. Also, ensure the water flow rate isn't too high (over 6L/min) by adjusting the water supply valve. Check the power supply voltage without heating to ensure it's sufficient. Finally, measure the actual voltage while heating to ensure the voltage drop isn't excessive.
L
Lauren DorseyAug 14, 2025
How to fix cold water coming from my Ariston Water Heater?
- B
  Brandon RiceAug 14, 2025
  If your Ariston Water Heater is dispensing cold water without a temperature increase, consider the following: * Verify the power supply is available by checking your house's voltage. * Ensure the water flow rate is adequate (over 1.2L/min but not exceeding 6L/min); if it's too high, reduce it using the water supply valve. * Make sure the heater is turned ON via the ON/OFF button and that it's not in cold water mode. * Confirm the water pipe connections are correct (inlet on the right, outlet on the left). * Also, check that the 'TEST' button hasn't been accidentally pressed; if so, press the 'reset' button to illuminate the ELCB lamp. If problems persist, stop using the water heater and call for service.
R
Rachel CastroAug 22, 2025
What to do if the flow rate is too small in my Ariston AURES TOP 4.5P?
- R
  Roberta GriffithAug 22, 2025
  If the water flow rate from your Ariston Water Heater is too low, make sure the water pressure is sufficient for a comfortable flow. Also, check and clean the filter built into the water supply valve to remove any dirt. Finally, ensure there are no restrictions in the inlet pipe between the water heater and the main water supply point.
A
Amber SmithAug 29, 2025
Why do the house lights flicker when my Ariston AURES TOP 4.5P Water Heater is heating?
- L
  lindsey48Aug 29, 2025
  To address flickering house lights when your Ariston Water Heater is heating, measure the voltage while heating to ensure the voltage drop isn't too significant. Increasing the power supply cable's section or reducing its length might also resolve the flickering.