What to do if my Ariston Water Heater has no hot water?
If your Ariston Water Heater isn't producing hot water even with the faucet fully open, first, check the circuit breaker and voltage at the wiring block. Next, clean the filter screen. Then, turn the circuit breaker off, open the hot valve to release pressure, and finally, turn the circuit breaker back on.
How to make Ariston Water Heater water less hot?
If the water from your Ariston Water Heater is too hot, try increasing the flow rate via the outlet tap. Additionally, switch to a lower temperature setting on the heater.
How to fix Ariston AURES S 3.5 COM PL Water Heater not hot enough?
If your Ariston Water Heater isn't producing water hot enough, reduce the water flow rate via the outlet tap. You might also want to switch to a higher temperature setting. Check that the mains stop valve is fully open and there are no supply line restrictions. If problems persist, have the heater checked by a qualified electrician or contact your local authorized distributor.
Why does my Ariston AURES S 3.5 COM PL Water Heater keep switching off?
If your Ariston Water Heater switches off during use, it could be due to an interruption in the electrical supply, an ELSD trip, or possible earth leakage. Check the incoming power supply, MCB, switches, and supply cabling. Also, check for earth leakage and reset the ELSD. If the problem continues, it's best to seek assistance from your local authorized distributor.
Why does Ariston AURES S 3.5 COM PL Water Heater temperature fluctuate?
If the water temperature from your Ariston Water Heater varies from hot to cold during use, it could be that the water pressure has dropped below the minimum level. Try to increase the hot water supply to resolve this issue.
What to do if Ariston AURES S 3.5 COM PL stops water flow?
If water ceases to flow from your Ariston Water Heater, it may be due to a blockage of the spray head, a twisted or blocked flexible shower hose, or a lack of water supply. Try cleaning or replacing the spray head and check the hose for free passage of water, replacing it if necessary. Also, check the water supply to ensure the stop valve is open and there are no blockages.
General information regarding the installation of the appliance by qualified technicians.
Specific instructions for installing sink and shower units of 3kW to 9.5kW power.
Instructions for periodic cleaning of the spray outlet and showerhead.
Guidance on adjusting the showerhead for different spray settings and flow.
Instructions for sink unit installation, focusing on ring combinations for seasonal use.
Electrical installation diagram for one-phase units up to 6kW.
Electrical installation diagram for one-phase units from 7kW to 9.5kW.
Electrical installation diagram for two-phase units from 5.5kW to 9.5kW.
General| Power | 3.5 kW |
|---|---|
| Frequency | 50/60 Hz |
| Overheat Protection | Yes |
| Material | Plastic |
| Type | Instantaneous |
| Installation | Wall |
| Heating time | Instantaneous |
To Next Page