How to troubleshoot cold water from Ariston AURES EASY 3.5 with no temperature increase?
If you're getting cold water from your Ariston Water Heater with no temperature increase: 1. Check your house power supply voltage. 2. Ensure the “ELCB” button is not pressed. 3. Confirm the water heater is turned ON via the knob. 4. Verify the water pipe connections are correct (inlet on the right, outlet on the left).
What to do if Ariston Water Heater temperature is increased, but not warm enough?
If your Ariston Water Heater isn't getting the water warm enough, try these steps: First, increase the temperature setting. Second, reduce the water flow rate to no more than 6L/min using the water regulation valve. Third, check the voltage while heating to ensure the voltage drop isn't too significant; increasing the diameter or shortening the power supply cable might help. Lastly, verify the house power supply voltage without heating to ensure it's adequate.
How to fix house light flickering when Ariston AURES EASY 3.5 Water Heater is heating?
If your house lights flicker when your Ariston Water Heater is heating, measure the voltage while it's heating to ensure the voltage drop is not too significant (it should be less than 10%). Increasing the wire gauge or reducing the length of the power supply cable could solve the flickering problem.
What to do if Ariston AURES EASY 3.5 flow rate is too small?
If the water flow rate from your Ariston Water Heater is too small, first ensure the water pressure is high enough (the water tank should be at least 3 meters above the water heater). Second, check for and remove any blockages in the built-in water filter inside the water valve. Third, clear any obstructions in the shower head nozzles. Finally, make sure there's nothing blocking the water flow from the main water supply to the inlet pipe.
Important safety notes and recommendations to be followed before proceeding with the appliance installation.
Step-by-step guide for physically mounting the water heater and its accessories in the bathroom.
Instructions for correctly connecting the water inlet and outlet pipes to the appliance.
Procedure to test water connections and fill the heater tank before electrical connection.
Critical safety guidelines and steps for making the electrical wiring connection to the water heater.
Steps to safely turn on and begin using the water heater after installation.
How to control and adjust the water temperature using the appliance's settings.
Procedure for regularly testing the Earth Leakage Circuit Breaker (ELCB) for safety.
Guidelines on what cleaning agents to use or avoid for maintaining the appliance.
Instructions on how to locate, remove, and clean the internal water filters to prevent blockages.
General| Power | 3.5 kW |
|---|---|
| Voltage | 230 V |
| Minimum Water Flow Rate | 1.2 l/min |
| Heating Time | Instantaneous |
| Frequency | 50 Hz |
| Thermostat | Yes |
| Type | Instantaneous Electric Water Heater |
| Amperage | 15 A |
| Installation | Wall-mounted |
| Water Connection | 1/2 inch |
| Temperature Control | Manual |
| Safety Features | Overheat protection, Pressure relief valve |
| Material | Plastic |
To Next Page