Ariston AURES M 6 User Manual (English)

Questions and Answers:

B
boonesamanthaAug 4, 2025
What to do if Ariston Water Heater has no hot water despite fully open hot water faucet?
- T
  Teresa HallAug 4, 2025
  If there is no hot water even when the hot water faucet is fully open, first, check the circuit breaker and voltage at the wiring block to ensure there is electrical power. Also, the activation flow rate needed to turn on the heating element might not have been reached. Try cleaning the filter screen, turning the circuit breaker off, opening the hot valve to release pressure from the unit, and then turning the circuit breaker back on.
L
Lisa OrtizAug 9, 2025
Why Ariston AURES M 6 Water Heater switch off during use?
- M
  Melissa Ritter DVMAug 10, 2025
  The Ariston Water Heater might switch off during use due to an interruption of the mains electrical supply. Check the incoming power supply, MCB, switches, and supply cabling. It could also be due to an ELSD trip, possibly caused by earth leakage. In this case, check for earth leakage and reset the ELSD. If the problem persists, call your local authorized distributor for assistance.
A
amanda42Aug 14, 2025
How to fix Ariston AURES M 6 water not hot enough?
- D
  davisjessicaAug 14, 2025
  If the water from your Ariston Water Heater is not hot enough, it could be due to several reasons. First, too much water might be flowing through the heater; try reducing the flow rate via the outlet tap. Second, a reduction in the ambient temperature may be the reason, so switch to a higher temperature setting. Third, the water pressure might be below 100 kPa; check if the mains stop valve is fully open and that there are no other restrictions in the supply line. Finally, an electrical malfunction could be the cause, in this case, have the heater unit checked by a qualified electrician or contact your local authorized distributor.
T
Tara ShafferAug 19, 2025
Why does Ariston AURES M 6 water temperature varies from hot to cold during use?
- K
  Kathryn GalvanAug 19, 2025
  If the water temperature from your Ariston Water Heater varies from hot to cold during use, it is likely that the water pressure has dropped below the minimum level. Increase the hot water supply to resolve this issue.
D
Dr. Wayne ShahAug 25, 2025
What to do if Ariston AURES M 6 water is too hot?
- S
  Steven MillerAug 26, 2025
  If the water from your Ariston Water Heater is too hot, it could be due to not enough water flowing through the heater; try increasing the flow rate via the outlet tap. Also, an increase in the ambient temperature may be the reason, so switch to a lower temperature setting.
A
andrewburtonAug 30, 2025
What to do if Ariston AURES M 6 water ceases to flow?
- M
  Michele MillerAug 30, 2025
  If water ceases to flow from your Ariston Water Heater, it could be due to a blockage of the spray head or a twisted/blocked flexible shower hose. Clean or replace the spray head and check for free passage of water through the hose, replacing it as necessary. Another reason could be no water supply, so check the water supply, ensure the stop valve is open, and verify there are no blockages.

Ariston AURES M 6 Specifications

General

Voltage	230 V
Protection Degree	IP25
Frequency	50 Hz
Installation	Wall-mounted
Water Connection	1/2 inch
Safety Features	Overheating protection
Type	Instantaneous
Temperature Range	30 - 60 °C