Ariston AURES PREMIUM User Manual (English)

Questions and Answers:

Z
zacharyperkinsAug 10, 2025
What to do if Ariston AURES PREMIUM Water Heater cold water no temperature increase?
- B
  Billy TateAug 10, 2025
  If your Ariston Water Heater isn't increasing the water temperature, check the following: ensure power is available by checking your house's power supply voltage; make sure the 'TEST' button isn't pressed—press the 'reset' button to turn on the ELCB lamp; ensure the water flow rate is adequate (over 1.2L/min); verify the water heater is turned ON by rotating the knob clockwise past MIN; check the water pipe connections (inlet on the right, outlet on the left); reduce the water flow rate if it's too high (over 6L/min) using the regulation valve. If the issue persists, stop using the water heater and call for service.
J
Jeremy CruzAug 18, 2025
Why is my Ariston AURES PREMIUM Water Heater temp increased, but not warm enough?
- S
  Stephen GarrettAug 18, 2025
  If your Ariston Water Heater is increasing the water temperature, but not enough, try these steps: increase the temperature/power setting; reduce the water flow rate if it's too high (over 6L/min) by adjusting the stop valve regulation; measure the voltage while heating to ensure the voltage drop isn't excessive—increasing the cable section or reducing its length might help; check the house power supply voltage without heating to ensure it's sufficient.
T
Tyler HuffAug 25, 2025
How to fix small flow rate in Ariston AURES PREMIUM Water Heater?
- S
  Samuel FloresAug 26, 2025
  To address a small flow rate in your Ariston Water Heater: ensure the water pressure is sufficient for a comfortable flow; clean the filter built into the regulation valve to remove any debris; and check the inlet pipe between the water heater and the main water supply for any bottlenecks.
T
timschroederSep 1, 2025
What to do if house light flickering when Ariston AURES PREMIUM Water Heater is heating?
- K
  Kathy AndersenSep 1, 2025
  If your house lights flicker when the Ariston Water Heater is heating, measure the voltage while heating to ensure the voltage drop isn't too significant (it should be less than 10%). Increasing the power supply cable's section or reducing its length could resolve the flickering.