6
Water heater description (figure 1)
a) Pilot lamp d) Front panel
b) Cap e) Spacer
c) Thermometer f) Control knob
Technical characteristics
For technical characteristics, please refer to the appliance data plate.
Approved marks
Made in ITALY
Model
Maximum
pressure
Power absorbed
Supply voltage
Current intensity
Capacity
Date of manufacture
Heater protection
Power frequency
Grade of protection
APPLIANCE WEIGHT WITHOUT WATER CONTENT
50 80 100 120 150
TI Q B - TI Q H - TI Q R 20 25 29 36 41
This appliance conforms to the provisions of the EMC 89/336/CEE regulation for
electromagnetic compatibility.
General instructions
National regulations could provide for restrictions as to the installation in bathrooms.
The installation is the responsibility of the buyer. The manufacturer is only liable for
damage caused by manufacturing defects. Therefore any responsibility for damages
that cannot be attributed to such defects is excluded, such as for example damages
caused by incorrect installation, usage not conforming to the safety regulations, installation
or use not conforming to the instructions contained within this booklet; in particular:
1) The electrical connection must be carried out in conformance with the instructions
given in the relative paragraph.
2) The safety valve, if supplied together with the appliance, must not be tampered with.
3) A qualified professional must perform the installation.
4) The earthing must be carried out according to good practice.
5) Should the user be absent for a considerable amount of time, we recommend that
the appliance's electricity and water supply to be disconnected from the mains
supply.
6) The appliance is first and foremost for domestic use.
GB
Model
Capacity
To Next Page
Loading...
Need help?
General
