2X-A Series Operation Manual 27
Manually starting evacuation sounders
To start the evacuation sounders for a single evacuation area, press the
corresponding evacuation area Start/Stop button, and then press Confirm.
To start the evacuation sounders for all evacuation areas, press the All
Evacuation Start/Stop button, and then press Confirm.
A steady evacuation area alarm LED indicates that the evacuation sounders are
active (sounding). A flashing evacuation area alarm LED indicates that a
configured delay is counting down and that sounders will activate when the delay
elapses.
Note: Evacuation panels only. This feature is subject to previous configuration by
your installation or maintenance contractor and operations associated with
programmable buttons and LEDs may differ from those described here.
Manually stopping evacuation sounders
To stop the evacuation sounders for a single evacuation area, press the
corresponding evacuation area Start/Stop button, and then press Confirm.
To stop the evacuation sounders for all evacuation areas, press the All
Evacuation Start/Stop button, and then press Confirm.
Note: Evacuation panels only. This feature is subject to previous configuration by
your installation or maintenance contractor and operations associated with
programmable buttons and LEDs may differ from those described here.
Enabling or disabling a previously configured sounder, fire routing, or fire
protection delay
To enable a previously configured sounder, fire routing, or fire protection delay,
press the corresponding Sounder, Fire Routing, or Fire Protection Delay button.
To disable the delay, press the button again.
Note: Availability of this feature is subject to previous configuration and its
functionality may vary for each zone. Contact your installation or maintenance
contractor to confirm all configuration details for your site.
To Next Page
Loading...
Need help?
General
