Aritech 2X-A Series User Manual

28 2X-A Series Operation Manual
Viewing reports
To view system status reports for the control panel and connected devices,
select Reports from the Main menu. Report information for this user level is
shown in the table below.
Table 12: Reports available to operator users
Report
Description
Event log
Displays all alarm, fault, and condition events logged by the
control panel
Attention required
Displays all devices reporting a fault condition
Revision
Displays your control panel software revision, control panel
configuration revision, and system boards serial number data
Contact details
Displays contact information for your installation or
maintenance contractor (subject to installer configuration)
Zone statu
s [1] Displays the current status information for zones
Device status [1]
Displays the current status information for control panel
devices
Panel I/O status
Displays the current status information for the control panel
inputs and outputs
Output
groups status [1] Displays the control panel output groups (sounders, fire
routing, fire protection, or program) that are currently active
Rules status
Displays the control panel rules that are currently active [2]
Firenet status
Displays the current status for all control panels in the fire
network
[1]
These reports are not available on repeater panels.
[2]
A rule consists of one or more states (combined by Boolean operators) that are configured to
trigger specific system actions after a
specific confirmation time. Rules are created by your
installation or maintenance contractor.
Note: To check the firmware version of your control panel, select Revision report
and then select Firmware version.

Aritech 2X-A Series Specifications

General

Brand	Aritech
Model	2X-A Series
Category	Smoke Alarm
Language	English