Aritech 2X-A Series User Manual

2X-A Series Operation Manual 29
Changing your password
Caution: To ensure system security, always change default passwords.
Use the Password setup menu to change your password.
To change your password:
1. Select Password setup from the Main menu, and then select Change
password.
2. Enter your current password.
3. Enter and then confirm your new password.
4. Press F4 (Enter), and then press F1 (Back).
5. Press F1 (Save), F3 (Apply), F4 (Discard), or F2 (Exit).
Remember to apply saved settings from the Main menu.
Figure 6: Changing the operator password
Performing an LED and buzzer test
Perform a LED and buzzer test to confirm that the LED indicators and control
panel buzzer are working correctly.
To perform an LED and buzzer test:
1. Select Tests from the Main menu.
2. Select UI tests, and then Indicators test.
During the test the control panel buzzer sounds and all LED indicators are
steady.
The test continues for two minutes. Press F2 (Exit) to exit the test before the
default timeout.

Aritech 2X-A Series Specifications

General

Brand	Aritech
Model	2X-A Series
Category	Smoke Alarm
Language	English