Page 14
User Manual for CD72/95/15003
0 + code
Enter Code ****
In this example, areas 1 and 2 are disarmed.
Area 1 Disarmed
Area 2 disarmed
You have a few seconds to enter the number of the area
you want to arm.
Enter Area No.
3. Enter the area number (in this example it is 1).
1
Arm Menu
4. Press the
Accept
key.
!
!!
!
Normal Set
5. Press the
Accept
key again.
!
!!
!
Normal Set
"
The system has identified zones in the area that are not
properly closed.
Open Zone(s)
It then proceeds to list the open zone(s). In this example,
zone 2 is open. The display is blinking.
002 Hall
6. Press
"$
"$"$
"$
to exclude a zone from the area.
"
""
"
Inhibit Zone ___
7. Press the number of the open zone, in this example ‘2.’
2
Inhibit Zone 2
The system then confirms which zone you have excluded.
002 Hall
If there still is a zone open, it will be listed, and you must
again press
"
""
"
and the zone number to inhibit it.
Is Inhibited
The alarm is being set.
Area 1 Arming
8. The buzzer begins to beep. You must now quit the
secured area.
Beeeep
You must now exit the protected area by the designated
exit route.
Leave now
The alarm is now set.
Area 1 Armed
Area 2 Disarmed
Enter Area No.
TUE 23 APR 08.22
To Next Page
Loading...
Need help?
General
