Aritech VE736AM User Manual

© 2021 Carrier P/N 149973999-3-ML • REV M • ISS 10JUN21
VE700AM Series Vector Enhanced Motion
Sensor Installation Sheet
EN
DA
DE
ES
FR
IT
NL
PL
PT
SV
1
2
3
4
5
6
C
l
i
c
k
!
A A
C
C
B B
D
D
A
B
A
B
C
C
C
C
A
B
A
B
D
D
D
D
DIN 7996
(3.5 mm x 35 mm)
DAY/NIGHT
WALK TEST
C V
10
11
10
11
10
11
10
11
NIGHT
DAY
ON
OFF
Control panel

Aritech VE736AM Specifications

General

Operating Voltage	9 - 16 VDC
Operating Temperature	-10°C to +55°C
Compatibility	Aritech Advisor Advanced, ATS Master
Output	Normally Closed (NC) Relay
Housing Material	Plastic

Summary

Mounting the Detector

Prepare the Detector Housing

Steps to open the detector, remove the interior part, and prepare for mounting.

Mount the Base

Instructions for fixing the detector base to the wall using appropriate screw positions.

Wire and Configure Detector

Connect the detector wiring and select initial jumper/DIP switch settings.

Finalize Installation

Replace interior parts, align the detector, and add optional stickers or blinders.

Setting the Detector

Jumpers

Details on J1 (PIR sensitivity), J2 (Curtain Location Mode), and J3 (Dual loop) jumper functions.

PIR DIP Switches

Configuration options for PIR detection, including polarity, chime, direction, and LEDs.

AM DIP Switches and Testing

AM DIP Switch Functions

Configuration settings for anti-masking (AM) and technical fault (TF) outputs.

Testing Anti-Masking

Procedure to test the anti-masking functionality using DIP switch settings and hand placement.

Aligning and Walk Testing

Alignment with VE710 Tool

Step-by-step guide for aligning the detector using the VE710 alignment tool.

Alignment without Tool

Method for aligning the detector using mirror blinders and walk testing.

Detector Status and Configuration

LED Status Indications

Explanation of different LED states to identify detector status and events.

Coverage Pattern and Blocking

How to change coverage patterns with stickers and block curtains with blinders.

Tamper Protection

Details on the detector's pry-off and cover tamper features and their implementation.

Detector Testing and Faults

Remote and Self-Testing

Procedures for testing the detector via control panel (remote) or internal monitoring (self-test).

Technical Fault Reset

Methods for resetting technical faults detected by the unit, including authorized and auto reset.

Regulatory Information

Product Warnings and Disclaimers

Important safety information, installation qualifications, and warranty details.

Certification and Compliance

Details on compliance with standards like ICES-003, FCC, REACH, and CE marking.