ARM AMBA NIC-301 - Table 3-1 Registers for each ASIB

Programmers Model
ARM DDI 0397G Copyright © 2006-2010 ARM. All rights reserved. 3-4
ID031010 Non-Confidential
The type defines the number of register blocks in a single AMBA Network Interconnect
configuration. Table 3-1, Table 3-2 on page 3-5, and Table 3-3 on page 3-6 show the register
block sub-types for each of the main types.
Table 3-4 on page 3-7 shows the address region control registers and Table 3-5 on page 3-8
shows the peripheral ID registers.
Note
In Table 3-1 to Table 3-5 on page 3-8, reserved means:
• read as zeros
• writes are ignored.
AHB only means that this register is interpreted as reserved if the interface is not AHB.
Table 3-1 shows the registers that exist for each ASIB.
Table 3-1 Registers for each ASIB
Address
offset
Type Width
Reset
value
Name Description
0x000 -- - - Reserved.
0x004 -- - - Reserved.
0x008 -- - - Reserved.
0x00C -- - - Reserved.
0x020 RW 3 4 sync_mode This register is only present if you configure the block as a
programmable FIFO. You can configure the register bits as follows:
0 sync 1:1.
1 sync n:1.
2 sync 1:n.
3 sync m:n.
4 async.
5 reserved.
6 reserved.
7 reserved.
0x024 RW 1 0 fn_mod2 Bypass merge. This register is only present if upsizing or downsizing, see
Upsizing data width function on page 2-12, Downsizing data width
function on page 2-14, and Bypass merge on page 2-13.
0x028 RW 3 0 fn_mod_ahb This register is valid for AHB interfaces only. You can configure the
register bits as follows:
0
rd_incr_override.
1 wr_incr_override .
2
lock_override.
See Lock transactions on page 2-7 for information on overriding locks.
See Combination 4 on page 2-6 for information on wr_incr_override and
rd_incr_override .
0x02C - 0x03C -- - - Reserved.
0x040 RW 4
a
wr_tidemark Valid only with a FIFO for the WFIFO channel, and if not an AHB slave
interface. See FIFO and clocking function on page 2-15 for information
on wr_tidemark .