88 89
CZ CZ
into the watch and cause damage. Upon coming into contact
with water, immediately dry the watch thoroughly. Damage by
water or steam is not covered by warranty.
5. You have stopped receiving incoming calls or SMS notifica-
tions – check that the watch is paired with your phone and
the notifications are allowed in the app [Notifications (Fig. 3)]
and in the settings of your phone, and that the do-not-disturb
mode has not been activated in the app. Make sure Bluetooth
is on in your phone. Do not pair the watch via the phone’s
Bluetooth menu.
6. The watch cannot be paired with a phone – possible solutions:
- make sure the watch and phone are charged sufficiently
- make sure your phone’s Bluetooth and GPS are switched on
and you have allowed your location/position to be
determined in your phone’s settings
- place the watch and the phone next to each other
- check the system updates in your phone
- uninstall and re-install the app
- restart your phone and switch it off then back on again
- make sure your phone meets the technical requirements
(Android 5.1+, iOS 9.0+, Bluetooth 5.0+)
7. Sensor light is blinking – data measurement or transfer is
underway.
8. The green sensor light blinks even when the watch is not
being worn – it is not a flaw.
9. To ensure the correct function of the watch, it is recommen-
ded that it be restarted or reset occasionally and, where
available, that firmware be updated in the app. Make sure you
always have the most recent version of the app.
10. Always charge the watch for no more than 2 hours (at no
more than 5 V). Improper charging reduces the capacity
and useful life of the battery. Battery life depends on the
ambient temperature and the number of functions actively
Other functions must be set and allowed in the WearPro app
(Fig. 3), and their operation depends on both the specific phone
model and settings as well as the current version of the watch.
These include various notifications (calls, SMS, social media),
alarm, remote shutter, do not disturb mode, prolonged sitting
reminder, display activation by wrist movement, etc.
ttt
1. To save the values measured and the current date and time,
make sure you synchronise the watch with the app on a daily
basis. During the night, the values measured by the watch
may reset.
2. This product is not a medical device. Neither the watch nor
the app are intended for the diagnosis, treatment or prevention
of illnesses and symptoms thereof. The values measured are
illustrative and may differ from values measured by certified
medical devices as well as because of the method of
measurement and tightness of the strap. The sensor on the
reverse side of the watch must be in contact with the wrist, and
the strap must be tight. If the strap is loose and the sensors
dirty, the precision of the measurements will be compromised.
3. In order to ensure correct date and time settings, the watch
must be paired with a phone. Then the date and time will be
set automatically.
4. We strongly recommend preventing the watch coming into
contact with water. The watch is not to be used in wet envi-
ronments, e.g. when bathing, swimming, showering, diving,
etc. The watch is not water resistant and water may damage
the interior. Attention must also be paid to hot (warm) water,
steam, etc., as it may (due to wear and tear of the casing,
mechanical damage or microscopic cracks in the seal) seep
ENEN
To Next Page
Loading...
