Need help?Do you have a question about the Armstrong 4030 and is the answer not in the manual?
General| Brand | Armstrong |
|---|---|
| Model | 4030 |
| Category | Water Pump |
| Language | English |
Provides specific information regarding the safe installation, operation, and maintenance of Vertical In-Line pumps.
Outlines requirements for installation and operation by trained personnel, emphasizing study and understanding of this document.
Details temperature limits, noise levels reference, and guidelines for storing pumps to prevent rusting.
Instructions for inspecting and handling pumps after receiving them, emphasizing careful lifting and checking for damage.
Details methods for lifting large Series 4300 units using motor lifting rings or straps.
Advises on locating the unit in open and closed systems for optimal operation and maintenance access.
Discusses ensuring the pump is pipe-mounted and free to float with piping movement.
Emphasizes careful alignment, starting piping from the pump, using minimal bends, and ensuring no strain on flanges.
Details verification of alignment for Series 4300 units by checking the gap between coupling halves.
Ensures the pump turns freely, is fully primed, and checks rotation before starting with the discharge valve closed.
Provides guidelines for keeping the unit clean, providing overload protection, and avoiding overheated surroundings.
States that lubrication is not required for the pump, but provides guidance for motor lubrication.
Explains the mechanical seal flush line and advises on proper operation and potential initial 'weeping'.
Stresses the importance of cleaning, flushing, and draining the system before starting the pump.
States that damages resulting from failure to observe precautions are not covered and advises contacting Armstrong.
Presents various installation arrangements with figures, including pipe mounted, ceiling mounted, and floor supports.
To Next Page