Arneg Astana LX User Manual (English)

Questions and Answers:

L
Luis CunninghamAug 6, 2025
Why does my Arneg Astana LX cabinet stop and not restart?
- C
  coxjenniferAug 6, 2025
  The Arneg Display Case might fail to restart due to several reasons: * A power black-out: check the cause of the black-out. * The master switch is turned off: turn on the switch. * The plug is detached: insert the plug. * Breakers triggered (fuses, thermal breakers/differential switches): check the temperature of the condensing unit. * Electric controller faulty: replace the controller.
T
Timothy BryantAug 11, 2025
Why is my Arneg Astana LX Display Case cabinet temperature too high or too low?
- D
  Dakota AustinAug 11, 2025
  The temperature inside the Arneg Display Case might be incorrect due to: * Poor room conditions: check the position of the cabinet inside the store. * Output air temperature is outside the specified range: check the operation of the evaporator fan. * The cabinet is defrosting: check wiring and input voltage. * The capacitor or the evaporator are freezing: the fans are installed reversely; check and restore the airflow direction. * The capacitor or the evaporator are obstructed or dirty: check that the fan plenum is sufficient and not obstructed. * Uneven load distribution: load the goods in an orderly fashion.
E
Ernest LesterAug 17, 2025
What to do if my Arneg Display Case does not cool sufficiently?
- J
  Joseph VargasAug 17, 2025
  If your Arneg Display Case isn't cooling properly, it could be due to the following reasons: * The cabinet is in defrosting phase: wait for defrosting to complete (about 30min). * Air inlets are obstructed: release air inlets. * The load is not distributed evenly: load the goods in an orderly fashion. * The cabinet is next to air currents or heat sources: check the position of the cabinet inside the store. * The cabinet is not levelled: level the cabinet. * Evaporator frozen: thaw it.