4
REV 5 22/01/2013
P-2213
P-2213
ARNOTT AIR SUSPENSION COMPRESSOR
FOR 1997-2006
FORD EXPEDITION/LINCOLN NAVIGATOR
3. USING THE PLASTIC DRYER PLUGS SUPPLIED WITH THE NEW COMPRESSOR, PLUG THE EXTRA HOLES
IN THE TOP OF THE AIR DRYER.THESE PUSH IN LIKE THE AIR LINE. 4WD MODELS USE TWO (2) AIR LINES,
WHILE 2WD MODELS USE ONLY ONE AIR LINE. (FIGURE B)
AIR SUSPENSION COMPRESSOR INSTALLATION
1. INSTALL THE AIR LINE(S) INTO THE AIR DRYER. THE DRYER CONTAINS SELF-LOCKING COLLETS. MAKE
SURE THEY ARE INSERTED ALL THE WAY IN TO PREVENT LEAKAGE.
2. PLUG IN THE ELECTRICAL CONNECTOR.
3. FASTEN THE ASSEMBLY TO THE VEHICLE USING THE ORIGINAL THREE (3) MOUNTING BOLTS.
4. REINSTALL THE WASHER RESERVOIR.
5. TURN THE AIR SUSPENSION SWITCH TO THE ON POSITION.
6. RECONNECT THE BATTERY CABLE.
FIGURE B
To Next Page
Loading...
