Arnott P-2932 - User Manual

1
REV 3 02/21/2018
P-2932
P-2932
ARNOTT AIR SUSPENSION COMPRESSOR
FORD EXPEDITION/LINCOLN NAVIGATOR
CHASSIS: UN173 2WD/4WD, U228
Congratulations on your purchase of an Arnott
®
air suspension product. We at Arnott Incorporated are proud
to offer a high quality product at the industry’s most competitive pricing. Thank you for your condence in us
and our product.
Proper installation is essential to experience and appreciate the benets of this system. Please take a moment
to review these installation instructions before you begin to install these components on your vehicle. The
removal and installation of air suspension products should only be performed by a fully qualied, ASE
Certied, professional.
It is equally important to be aware of all necessary safety measures while installing your new Air Suspension
System. This includes proper lifting and immobilizing of the vehicle and isolation of any stored energy to
prevent personal injury or property damage.
"Engineered to Ride, Built to Last
®
"
WARNING: The air suspension system is under pressure (up to 10 bar, or 150 lbf/in). Verify pressure has been relieved
and disconnect power to the air suspension system prior to disassembly. Do not allow dirt or grease to enter the system.
Always wear standard hand, ear, and eye protection when servicing the air suspension system.
Arnott
®
is committed to the quality of its products. If you have a question or problem with any Arnott product,
please contact Arnott by calling 800-251-8993 during normal business hours or email techassistance@arnottinc.com.
(In the EU please call +31 (0)73 7850 580 or email info@arnotteurope.com)

Summary

Introduction and Safety Overview

Welcome and Product Quality

Congratulates the user on their purchase, highlighting product quality and competitive pricing.

Professional Installation Requirement

Stresses the importance of installation by qualified, ASE certified professionals for proper system function.

General Safety and System Warnings

Covers essential safety measures like proper lifting, immobilizing the vehicle, and system pressure warnings.

General Information and Preparation

Terms of Use and Storage Guidelines

Covers agreement to terms, operational temperature limits, and protection of air lines and cables.

Vehicle Safety and Support

Emphasizes using correct jacking points and ensuring adequate vehicle support to prevent injury.

Initial Compressor Removal Steps

Details the first steps for removal: turning off the switch, opening the hood, and removing the reservoir tank.

Air Suspension Compressor Removal Details

Disconnecting Air Lines

Provides instructions on how to safely disconnect the air lines from the compressor assembly.

Disconnecting Electrical and Fasteners

Details the process for disconnecting the electrical connector and unbolting the compressor.

Compressor Pre-Assembly and Installation

Air Dryer Pre-Assembly

Instructions for plugging unused holes in the air dryer using supplied plastic plugs.

Installation Torque and Securing

Guidance on adhering to torque specifications and securing the intake baffle during installation.

Air Spring Condition and Warranty

Warranty Validation: Air Spring Integrity

States that cracked air springs must be replaced to validate the compressor warranty.

Air Spring Inspection Procedure

Outlines the steps for assessing air springs for cracks or excessive wear, which can cause compressor overheating.

Arnott P-2932 Specifications

General

Condition	New
Brand	Arnott
Part Number	P-2932
Type	Air Compressor
Voltage	12V
Max Pressure	150 PSI
Port Size	1/4" NPT