Arnott P-2936 - General Information and Safety; General Information; Important Safety Precautions; Air Suspension Compressor Removal

2 P-2936
REV 1 05/20/2016
P-2936
ARNOTT AIR SUSPENSION COMPRESSOR
FOR
1990-2011
LINCOLN/FORD VARIOUS CARS
AIR SUSPENSION COMPRESSOR REMOVAL
1. Turn air suspension switch to the off position (switch is located on the left side of the trunk).
2. Unlatch and remove air cleaner cover.
(FIGURES A, B)
GENERAL INFORMATION:
Reading this manual signies your agreement to the terms of the general release, waiver of liability, and hold harmless agreement,
the full text of which is available at www.arnottinc.com.
• Not to be stored below 5
o
F (-15
o
C) or above 122
o
F (50
o
C).
• Avoid damage to air lines and cables.
• Removal and installation is only to be performed by fully qualied personnel.
• Use car manufacturer’s diagnostic software.
CAUTION: Damage to the vehicle and air suspension system can be incurred if work is carried out in a manner other than specied
in the instructions or in a different sequence.
To avoid the possibility of short circuits while working with electric components consult your owner's manual on how to
disconnect your battery.
Consult your vehicle owner's manual, service manual, or car dealer for the correct jacking points on your vehicle and for
additional care, safety and maintenance instructions. Under no circumstances should any work be completed underneath
the vehicle if it is not adequately supported, as serious injuries and death can occur.
FIGURE A FIGURE B