STEP 5
5. Find a flat surface to place the desk boards on, make sure you protect the surface. You can use the
Styrofoam packing in the box to put under the desk boards and place the three boards desktop side
down. Align them as shown and slide the pegs into the holes so that they fit as close as possible.
STEP 6
6. Now put the metal frame feet upward and secure it to the desktop by inserting the screws in
package D to the metal frame.
READ MORE AT AROZZI.SE / AROZZI.COM
ARENA ASSEMBLY GUIDE
STEP 9
9. Before you turn the table you can adjust the height, loosen the screw closet to each foot and then
pull up the leg raise the height. You can use measurement tape to set your preference.
STEP 10
10. After you have set your desired please make sure it is stable. When you are done and have the
desk standing, use a level and make sure it is flat and the feet are firmly on the ground.
STEP 11
11. Roll out the mousepad and you are all done!
To Next Page
Loading...