Array electronic SR Series User Manual

Controladores lógicos programables PLC baja gama expandibles entradas digitales AC 74368-SR22MRDC ARRAY Manual Ingles www.viaindustrial.com
Controladores lógicos programables PLC baja gama expandibles entradas digitales AC 74368-SR22MRDC ARRAY Manual Ingles www.viaindustrial.com
Fig. 3.11
As shown in Fig. 3.11, coz’ the property pin is shelled when SLCD is set.
And the property pin of B0 is empty. And when the output pin of B0 is high, HMI will
show L:0 page automatically. But it will not show the parameters of B0.
Note£ºFor more information about property pin, please refer to Chapter IV.
3.3 Input & Output Blocks
There are 8 Input & Output function blocks in total as list in the following table.
Table 2: Input & Output Function Blocks
Block Graphic Function
IN
One IN point is correspond to
one input terminal of SR.
OUT
One OUT point is correspond
to one output terminal of SR.
RCI
The function key of remote
module.
DOUT
To dial the set telephone and
then play the set message.
D-IN
The function block to dial the
telephone and check the
alarming message.
PMSG To play the set message.
CONT
To program assistant. When
wiring, the line connects the
two points of the same code
and different directions.
SLCD
To edit the HMI, each SLC has
its correspondent HMI page.
3.3.1 IN
The symbol in SR is as follows:
Symbol in SR Function Explanation
Input Pin One IN point is correspond to one
input terminal of SR.
Function Explanation & Icon:
One IN point is correspond to one input terminal of SR.
Fig. 3.12

Array electronic SR Series Specifications

General

Brand	Array electronic
Model	SR Series
Category	Controller
Language	English