Array electronic SR Series

To Next Page

To Previous Page

Controladores lógicos programables PLC baja gama expandibles entradas digitales AC 74368-SR22MRDC ARRAY Manual Ingles www.viaindustrial.com

Fig. 23

Fig. 5.22 Wiring Diagram of Voice Module Recording

Fig. 24 Fig. 25

Fig. 23: Free audio wire accessory, to connect the voice audio input and PC audio

output.

Fig. 24: SR-CB, to connect the machine and the voice module and so on.

Fig. 25: SR-CP Cable, the private connecting wire with PC series port.

Recording Operation Procedures:

1. Connect telephone, voice module and SR machine rightly as the following

diagram.

2. Connect the power of the voice module and SR (Notes: Non-connecting of the

power now).

3. Connect it with PC series port via SR-PC.

4. Connect audio input of the voice module and audio output of PC via audio wire.

5. Confirm no failure of the connection and then power on. (Notes: Only machines

of the same type can be connected together.)

6. Start Super CAD software and newly build a file and open relative series ports.

7. Start Super CAD software and click “Option | Sound Record” to enter the

recording main interface as shown in Fig. 5.4.

8. Click button

in Fig. 5.4. The dialogue frame as shown in Fig. 5.7 will be

displayed.

9. Click button

in Fig. 5.7 and start to record. Length of the recording voice

message is better no longer than 15 seconds. (When recording, it is need to insert

Array electronic SR Series - Page 86