Array Solutions PowerMaster II - Page 14

PowerMaster II RF Wattmeter www.arraysolutions.com Rev 4.1 - February 23, 2017
14
High Power Alarm Menu
Push the mode select button to choose trip point in watts*:
Off
175
225
700
1,100
1,600
2,600
3,000
Note:
The yellow
POWER
ALARM LED
will flash on and
off
*(See the note about ranges for other couplers in the Low Power Alarm
Menu on the previous page).
If the peak power exceeds this setting the power alarm LED will flash
and the power monitor relay will cycle on and off. If the “Alarm Trips
Amp”, next menu, option is selected then the VSWR alarm LED will
also flash and the PTT/ALC relay will actuate but will not cycle.
Push the mode select button to reset the alarm and LED
Auto Alarm Reset Menu
This will automatically reset the both the VSWR and Power Alarms or
if “Off” will force a manual reset only.
Select by pushing the mode select button:
Off
1 second
2 seconds
5 seconds