PowerMaster II RF Wattmeter www.arraysolutions.com Rev 4.1 - February 23, 2017
JP1 is supplied with two “dip” jumpers as shown above.
Move the two jumpers so that they match the pattern above
After moving the jumpers as shown above, carefully place the cover back on the meter and reinstall the 4 screws (2 on either side).
At this point what you have done is connected the two coupler input jacks together as if they were one. So, we need to program the meter as if you only
have one coupler – not two! This will allow you to transmit through either coupler and the meter will display that transmitter’s output instantly without
any switching. If you transmit on both at the same time, whichever one is at a higher power level will be shown.
To Next Page
Loading...