What to do if Arrma 4x4 4S BLX Motorized Toy Car has no throttle or steering on start up and LED flashes red?
If your Arrma Motorized Toy Car exhibits no throttle or steering upon startup, and the LED flashes red with a single short pulse repeating, the issue is likely due to the throttle trim not being at neutral. To resolve this, turn off the ESC, adjust the throttle trim on the transmitter to neutral, and then turn the ESC back on.
Why Arrma 4x4 4S BLX motor won’t operate and LED flashes green with five short pulses?
If the motor of your Arrma Motorized Toy Car won’t operate and the LED flashes green with five short pulses repeating, it indicates that there is too much load on the drive system for the ESC to support. Consider changing the battery or gearing to reduce the load on the ESC, or adjust your driving habits to reduce the load.
What to do if Arrma 4x4 4S BLX Motorized Toy Car motor won’t operate and LED flashes green with short single pulses?
If the motor of your Arrma Motorized Toy Car won’t operate, and the LED flashes green with short single pulses, it means the ESC is taking too much load. Turn off the ESC and allow it to cool before resuming operation. You might also consider making changes to the gear ratio to reduce the load on the ESC.
General| Brand | Arrma |
|---|---|
| Model | 4x4 4S BLX |
| Category | Motorized Toy Car |
| Language | English |
Explains terms like WARNING, CAUTION, NOTICE used in the manual.
Provides essential safety rules for operating the RC model.
General safety and operational advice for using the vehicle in wet conditions.
Procedures for cleaning and maintaining the vehicle after exposure to water.
Lists the main components supplied with the ARRMA RC vehicle kit.
Step-by-step guide to installing batteries in the radio transmitter.
Instructions on how to remove the vehicle's body shell.
Guide to installing the vehicle's battery pack.
Instructions for connecting the ESC and powering on the system.
Demonstrates the correct way to hold the radio transmitter for optimal control.
Steps to set the steering to its neutral position.
Guide on how to attach the car body to the chassis.
Outlines the correct sequence for powering off the car and controller.
Instructions for safely storing the RC vehicle.
Provides technical specifications for the Electronic Speed Controller.
Step-by-step guide to calibrate and set up the ESC throttle.
Explains battery protection settings within the ESC.
Instructions on how to access and change ESC tuning parameters.
Guide to interpreting ESC status lights and their meanings.
Comprehensive guide listing common problems, their causes, and solutions.
Explains the functions of the steering wheel, throttle trigger, and trims.
Details how to check the battery status of the transmitter.
Steps to bind the receiver using the SLT protocol.
Steps to bind the receiver using the DSMR protocol.
Declaration of compliance with FCC and IC rules.
Information on the radio frequency bands and output power.
Comprehensive guide listing common problems, their causes, and solutions.
Covers issues like control loss, intermittent operation, and steering problems.
Explains what defects and damages are covered under the warranty.
Outlines the buyer's remedies and the seller's liability limitations.
Information on how to access warranty support and services.
Steps for submitting the product for inspection or service.
Details the requirements needed for a valid warranty claim.
Information on how to get repairs for issues not covered by warranty.
To Next Page
