Arrow Shark X-Hydro - Step 3: Rudder Assembly

*Therearefourplywoodboatstandpiecestwonarrowerpiecesthatformthesides, 
and two taller pieces that form the ends to support the bottom of your boat on
rubberpaddedsections.Matchtheangledslotsinthebottomofoneoftheendpieces
to similar slots in the top of the side pieces, and slipthem to gether. Repeat forthe
other end piece. Optionally, for a more secure st and, you could app ly CA glue or
epoxytothejointsofthestand.
Note:Thisboatstandisintendedfordisplayingyourboatatyo urhomeoroffice.Itis
notforfielduse.You shouldcustommakeastrongerboatstandfrom PVCorstainless
steelp ipeforfielduse.
Step 3:RudderAssembly
* Take out the rudder assembly from the accessory bag along with its installation
bolts.
*Usinga4mmhexwrench,securetherudderarmwiththetwoboltstothemounting
bracketthathasbeen preinstalledonthetransom (ieonthebackoftheboat). Applya
littleLoctite totheboltsbeforescrewingthemintothebracket.