P/N 80-9150-0064-010 Rev A

An ASSA ABLOY Group brand

(2) 8-32 x 3/4"

Flat Head

Combination Screws

Directions

Touchscreen Cable

Routing

(2) 8-32 x 3/4"

Flat Head

Combination Screws

EASY

EXT-PWR / REMOTE / MOTOR

Easy /

Advanced

Mode

ADVANCED

Touchscreen

Cable

Connector

EXT-PWR / REMOTE / MOTOR

"Z" Fold

Outside Assembly

Touchscreen

Cable

Escutcheon Screw

(1) 10-32 x 3/4" Pan Head

With Star Washer Screw

Motor Cable

Support Assembly Screws

(2) 10-32 x 2-1/2" Flat

Head Machine Screws

Inside Assembly

7. Attach the touchscreen cable connector to the inside escutcheon PC board

header as illustrated.

8. Select EASY or ADVANCED Mode using the switch on the back of the PC board.

9. Slide inside escutcheon over inside support assembly.

CAUTION:

a. Position motor cable against inside support assembly. Avoid pinching wires

against the steel shank of the assembly.

b. “Z” fold touchscreen wire cable and lay against the back recessed area of

the escutcheon assembly. Position and bend wires to prevent binding when

installing the escutcheon over the support assembly.

10. Install and secure the 10-32 x 3/4" pan head screw through the center of the

battery housing into the barrel nut of the outside assembly.

11. Slide on inside lever and push in to attach.

12. Insert four (4) AA alkaline batteries. The lock responds, “Welcome to the

Arrow Digital World.”

Note: Refer to other side of this Quickstart Guide for EASY Mode programming directions

prior to the completion of step 13. For more details and Advanced Mode programming,

please refer to the complete Programming Instructions.

13. Install battery cover and tighten hex head screw with Allen wrench

provided with lock.

8 7

HARDWARE INSTALLATION

Quickstart Guide

Components

Quick Start Instructions

Installation Instructions

Door Marker

Outside Touchscreen Assembly

Inside Support Assembly

Inside Escutcheon Assembly:

• Inside Support Assembly

• Inside Escutcheon

• Inside Lever Handle

• Battery Cover

4 AA Alkaline Batteries

Latchbolt

Strike

Allen Wrench 3/32” (2.5 mm)

Screw Pack (7 screws)

2 Keys (If Cylinder Included)

For Technical Assistance call Arrow:

1-800-221-6529.

Before installation, disassemble the inside assembly, as shown above, by

removing the inside lever with the lever removal tool provided and separating

the support assembly from the inside escutcheon. Remove the battery cover

from the inside escutcheon by unscrewing the hex screw, using the Allen wrench

provided, and sliding the battery cover up and off (the hex screw does not come

completely out). The outside assembly remains assembled.

Refer to complete installation instructions for more information if changing hands

or adjusting door thickness is required.

1. Install latchbolt in door. Attach with two screws provided.

Note: Be sure that bevel edge of bolt faces strike.

2. Install strike on the door frame.

3. Insert outside assembly through door.

a. Guide motor cable (red and black wires) through 2-1/8" diameter hole.

b. Guide touchscreen cable through 3/4" diameter upper hole.

4. Guide motor cable through rectangular hole on inside support assembly.

5. Slide inside support assembly over outside assembly, lining up top and

bottom screw guides with holes in door. Secure both assemblies with

(2) 10-32 x 2-1/2" ﬂat head machine screws. Do not over-tighten.

6. Attach motor cable connector to the inside escutcheon PC board header

marked “MOTOR.”

Arrow Revolution - Installation And Programming Instructions Manual

Table of Contents

Other manuals for Arrow Revolution