Discover other hand tools on our website.
OPERATIN
G INSTRUCTIONS
TO LOAD
1. Remove pusher rod from machine.
2. Insert strip of staples.
3. Replace pusher rod.
TO CLEAN STAPLE CHANNEL
1. Remove pusher rod A.
2. Remove screw a
nd nut from hole B.
3. Pull down entire inside frame for complete cleaning.
How to determ
ine staple shortage for rell.
1. Press latch to release pusher rod.
2. Lightly push rod forward until it stops. Visible projected
part of rod indicates amount of staples remaining in track.
1 For best results, the T25P Staple Gun is equipped
with extended grooved-blade to position wire for
proper envelopment of staple.
2. Uses 4 staple lengt hs: 9/32", 3/8", 7/16", 9/16".
Excellent for use with braided wire, single and
double strand wire, rubber coated wire, hollow
tube lines and other low voltage wire up to 1/4"
diameter.
3. Recommended for remote control wiring,
thermostat control wiring, audio system wiring,
alarm system wiring, pin ball machine wiring,
telephone installation wiring, television and radio
wiring, inter-communication wiring, CATV, and
many other wiring uses. Also used for stringing
wire.
T25
™
P
9/32"
7mm
3/8"
10mm
7/16"
11mm
9/16"
14mm
To Previous Page
Loading...
