Need help?Do you have a question about the Arrow T50DCD and is the answer not in the manual?
Keep work area clean, well lit, avoid explosive atmospheres. Match plugs to outlets. Protect from rain/wet conditions. Use RCD supply.
Stay alert, use PPE, prevent unintentional start, maintain balance. Use correct tool, ensure switch works, disconnect before maintenance.
Use correct charger, avoid extreme temperatures. Handle battery fluid with care. Service by qualified person, do not store in extreme temps.
Assume tool contains fasteners. Do not point tool at self/others. Place tool firmly against workpiece before actuating.
Hold by insulated surfaces. Know your tool. Wear safety glasses. Protect hearing and lungs. Do not abuse charger cord.
Describes tool components like trigger, battery indicator, charge port, and on/off switch.
Explains symbols like Volts (V), Amperes (A), Hertz (Hz), and Alternating Current (AC).
Tool comes assembled. Ensure safety instructions are read. Use bottom load magazine to load staples.
Place on workpiece, depress contact safety, then push trigger to fire. Operate in temperatures 32°F-104°F.
Consider material thickness and wood hardness. Aim for proper penetration. Use genuine Arrow® staples for best performance.
Plug charger into tool and wall outlet. Charging takes up to 1.5 hours. Disconnect charger when complete.
Details status lights for unplugged and plugged-in charger states, including good charge, low battery, and defective battery.
Charge between 65°F-75°F. Do not charge below +40°F or above +105°F. Wait 15 minutes after charging.
Tool is virtually maintenance free. Keep clean and free of dust. Wipe with a dry cloth. No user serviceable parts.
Arrow® staples are available at retail outlets. Lists available staple sizes and compatible tool models.
Warrants products free from defects for two years. Excludes normal wear, misuse, abuse, neglect, and batteries.
General| Brand | Arrow |
|---|---|
| Model | T50DCD |
| Category | Power Tool |
| Language | English |
To Next Page
