15
SPECIFICATIONS
EQUALIZER
Bands 2 x 15, 2/3 octave, ISO spacing (EQ341)
1 x 31, 1/3 octave, ISO spacing (EQ351)
2 x 31, 1/3 octave, ISO spacing (EQ355)
Type / Accuracy Constant-Q / 3% center frequency
Travel 20mm w/ positive center detent
Range ±6dB or ±12dB, selectable
Overall Gain Range Off to +6dB (unbalanced out) sliders centered
Off to +12dB (balanced out) sliders centered
INPUTS
Type Active balanced/unbalanced
Connectors 3-Pin XLR, 1/4” TRS (balanced), RCA (unbalanced)
Impedance 20k Ohms balanced; 15k Ohms unbalanced
Maximum Level +22dBm (level control at center)
OUTPUTS
Type Active balanced/unbalanced
Connectors 3-Pin XLR, 1/4” TRS (balanced), RCA (unbalanced)
Impedance <150 Ohms, typical
Maximum Level +18dBm (balanced) (600 Ohm load)
+22dBm (unbalanced) (2k Ohm load)
Passive Bypass Switches Yes
Overload LED Threshold 6 dB below clipping, (all filters set to flat)
High Pass Filter (EQ351,EQ355) 10-250Hz, 12dB/octave
Low Pass Filter (EQ351, EQ355) 3k-40kHz, 12dB/octave
Frequency Response 20-20kHz, ±0.5dB
THD + Noise .01%
Signal to Noise Ratio -94dB
Channel Separation >50dB
POWER (switchable)
95-130VAC, 50/60Hz
190-250VAC, 50Hz
POWER CONSUMPTION
12 Watts
SIZE
1.75” H *19” W *7” D (1U) (EQ351 and EQ341)
(4.45cm * 48.3cm * 17.8cm)
3.5” H *19” W *7” D (2U) (EQ355)
(8.9cm * 48.3cm * 17.8cm)
WEIGHT
7.1 Ibs (3.2 kg) (EQ351 and EQ341)
11.6 Ibs (5.2 kg) (EQ355)
To Next Page
Loading...
