Changing parameters via MIDI CCs
The MicroBrute allows you simple access to all the parameters found in the editor via easy to
use MIDI CCs. When parameters are changed using CCs, changes will be lost after a restart.
To write changes to internal memory you have to use the editor.
Parameter MIDI CC Value
Receive Channel 102 1 to 16, 17=All
Send Channel 103 1 to 16
Seq Retrig 104 0 to 41 = Reset
42 to 83 = Legato
84 to 127 = None
Seq Play Mode 105 0 to 63 = Hold
64 to 127 = Note On
Next Seq Mode 106 0 to 41 = End
42 to 83 = Instant Reset
84 to 127 = Instant Continuous
Seq Step Size 107 0 to 29 = ¼
30 to 59 = 1/8
60 to 89 = 1/16
90 to 127 = 1/32
Sync Source 108 0 to 41 = Auto
42 to 83 = Int
84 to 127 = Ext
Env Legato Mode 109 0 to 63 = Off
64 to 127 = On
LFO Retrig Mode 110 0 to 63 = Off
64 to 127 = On
Note Priority 111 0 to 41 = Last
42 to 83 = Low
84 to 127 = High
Velocity Curve 112 0 to 41 = Lin
42 to 83 = Log
84 to 127 = Anti Log
Gate Length 113 0 to 41 = Short
42 to 83 = Med
84 to 127 = Long
Seq Step/Gate Mode 114 0 to 63 = Clk
64 to 127 = Gate/Tap
Pitch Bend Range RPN 06 1 to 12
Local ON/OFF 122 0 = or 127
To Next Page
Loading...
