Arturia Prophet V - Page 94

ARTURIA – PROPHET V - MANUAL
94
Increase the LEVEL of point “0”
 Adjust the settings associated to point “1”: Increase the LEVEL to about 70 and set the
RATE to about 1400ms. The cutoff frequency will softly evolve creating a brighter sound
after three seconds. The phase between points “0” and “1” corresponds to the ATTACK of
the ADSR envelope.
Adjust the settings associated to point “1”
 Set point “2” by increasing the LEVEL to a value around 70 and the RATE to about 300ms.
This phase corresponds to the DECAY period of the ADSR envelope.
Set point “2”