3
to ensure it corresponds to the installation gas supply. If in doubt contact the supply
authority.
The power supply cord (supplied) must not touch any hot surfaces and must be placed so
that its temperature does not exceed 75 degrees at any point along its length.
Check for leaks using soapy solution, never a naked flame, after connecting to gas.
Where a flexible hose assembly is used, ensure it is approved to AS/NZS 1869, Class B
10mm diameter and no more than 1.0metre in length. Any hose assembly used must be
restrained from accidental contact with the flue outlet of an under bench oven.
How To Avoid Damage To The Appliance
Do not use the cooking zones with empty cookware or without cookware.
The ventilation gap of 5mm between the worktop and front of the unit underneath must not
be covered.
ALTERATION or MODIFCATION OF THIS APPLIANCE VOIDS THE WARRANTY.
Safety When Cleaning
Switch off the cooled appliance before cleaning.
For safety reasons, the cleaning of the appliance with steam jet or high pressure cleaning
equipment is not permitted.
Disposing Of The Device
Take it to an electrical and electronic waste recycling and reuse centre. A label
has been put on the device, its instructions manual, or the package. The device
has been manufactured of recyclable material.
Ask your local environmental care authority for information on location of such
facilities.
To Next Page
Loading...