What to do if burner is not lighting on Artusi CAGH6000B?
If the burner on your Artusi Hob isn't lighting even when the spark ignition is working, it could be due to a misaligned burner. Try removing and refitting the burner to ensure it's properly aligned. Alternatively, the burner ports might be blocked. In this case, remove, clean, and then replace the burner.
What to do if the burner goes out when safeguard control knob is released on Artusi CAGH6000B Hob?
If the flame goes out when you release the safeguard control knob on your Artusi Hob, it could be because the flame failure safeguard isn't activated properly. Try re-lighting the burner and allow more time for the flame safeguard to activate. If the issue persists, the flame safeguard might have a faulty connection or be broken, and you should contact an authorised representative.
Why is there an uneven flame pattern on my Artusi Hob?
If you notice an uneven flame pattern or slight flame lifting on your Artusi Hob, the burner ports might be blocked. To resolve this, remove, clean, and then replace the burner.
Why is the flame small on high setting on Artusi CAGH6000B?
If you're experiencing a small flame on a high setting on your Artusi Hob, this may be due to a blocked injector or gas supply tube, which requires calling an authorised representative. It may also be due to an incorrect injector being fitted, which also requires calling an authorised representative. Also, refer to the operating instructions utensil choice.
Why is the flame too high on high setting on Artusi CAGH6000B?
If the flame is too high on the high setting of your Artusi Hob, this could be due to a faulty regulator or an incorrectly fitted injector, both of which require attention from an authorised representative. Also, ensure you are using the correct pan, cookware, or utensil size by referring to the operating instructions utensil choice.
What to do if Artusi Hob has no power?
If your Artusi Hob has no power and there's no spark when you depress the gas control knob, first check the mains circuit breaker. Also, check for a loose sparker cable. If these steps don't resolve the issue, contact an authorised representative.
Safety measures related to children's interaction with the appliance.
Mandatory requirements and standards for a secure installation.
Pre-installation checks and clearance requirements for the hob.
Details on cutting the cupboard for the hob installation.
Procedure for making the correct electrical connections.
Steps and requirements for connecting the gas supply.
Instructions for setting and checking gas pressure for natural gas and LPG.
Table of common faults, their possible causes, and remedies.
To Next Page
General