7
1. Cupboard Cutting
Bench top thickness, 30– 40 mm (3 – 4 cm).
mm
mm
CAGH6000B CAGH7000B
mm
CAGH9000B
2. Place Burner Box
Apply the adhesive sealing tape to the underside lip of the burner box. Shown at G opposite.
Place burner box into cutout hole and fit clamping brackets to clamp the hotplate to the bench.
3. Fit Burners And Trivet.
Replace burners and ensure they are correctly repositioned over the ignitor (S) and thermocouple (T). The ignitor
(S) must be clean for trouble free sparking. Test burner ignition and burner flame for correct operation, If burner
is placed correctly it will not rotate on its supports..
To Next Page
Loading...