Aruba 203R Series User Manual

Aruba 203R Series Wireless Access Points | Installation Guide 3
Network Status (E1)
The Network Status (E1) LED indicates activity transmitted to/from the wired E1 port. See Table 3.
Table 3 Network Status LED
4 Flickering: the LED’s on/off cycle is active for irregular intervals.
Network/PSE Status (E2)
The Network/PSE Status (E2) LED indicates activity transmitted to/from the wired E2 port.
For Aruba 203RP access points, this LED also indicates when the access point is providing Power over Ethernet
(PoE) to an external device that is physically linked to the E2 port. See Table 4.
Table 4 Network/PSE Status LED
LED Display Settings
The LEDs have three operating modes that can be selected in the system
management software:
 Default mode: Refer to Table 1-4
 Off mode: LEDs are off
 Blink mode: LEDs blink green
Color/State Meaning
Off Meets one of the following conditions:
 device is powered off
 port is disabled
 no link established
Green/solid Link established
Green/flicker
4
Activity detected across link
Color/State Meaning
Off Meets one of the following conditions:
 device is powered off
 port is disabled
 no link established
Green/solid Link established
Green/flickering Activity detected across link
Blue/solid Link established; supplying PoE-out (Aruba 203RP only)
Blue/flickering Activity detected across link; supplying PoE-out (Aruba 203RP only)

Aruba 203R Series Specifications

General

Brand	Aruba
Model	203R Series
Category	Wireless Access Point
Language	English