Aruba ClearPass Policy Manager C1000 User Manual

9. You can choose to either specify an alternate location to store the virtual appliance's files or accept the
defaults:
a. To specify an alternate location to store the virtual appliance's files, click (enable) the Store the virtual
machine in a different location check box, specify the following folders, then click Next:
n Virtual machine configuration folder
n Snapshot folder
n Smart Paging folder
b. To accept the default folders for the virtual appliance's files, click Next.
The Choose Folders to Store Virtual Hard Disks dialog opens.
Figure 32 Specifying Folders to Store Virtual Hard Disks
10. Accept the default virtual hard drive storage folder, or browse to a new location to change it to your
preferred location, then click Next.
If the virtual appliance being imported was configured to use physical disks in pass-through mode, you will have the
opportunity to either remove the storage from the virtual appliance’s configuration or attach new physical disks in
pass-through mode.
If an error occurs indicating that the virtual switch "SwitchManagement" could not be found, the Connect
Network dialog opens.
Figure 33 Specifying the Virtual Switch in the Event of an Error
11. From the Connection drop-down, choose the virtual switch that will be used for the Management
interface on the ClearPass Policy Manager virtual appliance, then click Next.
ClearPass 6.7 Getting Started Guide 42

Aruba ClearPass Policy Manager C1000 Specifications

General

Brand	Aruba
Model	ClearPass Policy Manager C1000
Category	Server
Language	English