Aruba
6280 America Center Drive
San Jose, CA 95002
1.877.210.7325 (toll-free in USA)
+1.408.935.1850
www.silver-peak.com/support
EdgeConnect
Quick Start Guide
EC-US
© 2021 Aruba, a Hewlett Packard Enterprise company All rights reserved. PN 201784 Rev A
Before You Begin
Check your packing slip to verify
that you have all the necessary
items.
On the network equipment, iden-
tify the 10/100/1000 Ethernet
ports.
1
Install the Appliance into the Network
a. Identify the relevant ports on the rear of the appliance.
b. Connect the supplied network cables from the appliance to the identied network equipment
ports.
c. DO NOT connect the power cable yet.
All copper RJ-45 Gigabit Ethernet interfaces in the Silver Peak appliance support MDI/MDI-X and
auto-negotiation.
2
Connect Power Cord
Connect the power cable to the Silver Peak appliance and to your local power source.
3
Turn the Power On
a. The appliance powers up as soon as it’s plugged in.
b. On the front panel, verify that the Power LED illuminates green.
You’ve now completed the physical installation and are ready to register the product with Unity
Orchestrator.
Part 1 - Physical Installation
IMPORTANT - READ THIS FIRST: You must install and register your Orchestrator
with the Silver Peak Cloud Portal BEFORE setting up an EdgeConnect appliance. After
Orchestrator is registered with your account name and key, you can proceed with
EdgeConnect installation.
If you don’t know or are unsure what role the Orchestrator plays, please contact your
network architect or deployment lead.
Static Assignment of IP Address
If an IP address is not dynamically assigned to wan0 or wan1, then you
must congure it manually. To do this, access the appliance conguration
wizard through lan0.
Silver Peak assigns the lan0 ethernet interface a default IP address of
169.254.0.1 and a subnet mask of /16 (the same as 255.255.0.0).
To Next Page
Need help?
General
