Aruba S3500 Series Uplink Module | Installation Guide 3
Direct Attach Cables
Direct attach cables (DACs) are used to connect one S3500 with another when forming a stack. DACs are
installed in an uplink module in the same manner as an SFP module, using the 10GBASE-X Ports. For
information on how to install an SFP or a DAC, see "Installing an SFP" on page5. For a list of DACs
available through Aruba, see Table 3.
Table 2 Supported SFP/SFP+ Modules
SFP/SFP+ Description
SFP-SX Aruba SFP, 1000BASE-SX, LC Connector
SFP-LX Aruba SFP, 1000BASE-LX, LC Connector
SFP-TX Aruba SFP, 1000BASE-T, RJ-45 Connector
SFP-10G-SR Aruba SFP+, 10GBASE-SR, 850nm serial
pluggable SFP+ optic, LC Connector
SFP-10G-LR Aruba SFP+, 10GBASE-LR, 1310nm serial
pluggable SFP+ optic, LC Connector
SFP-10G-LRM Aruba SFP+, 10GBASE-LRM, 1310nm serial
pluggable SFP+ optic, LC Connector
Table 3 Direct Attach Cables
DAC Description
SFP+, Direct Attach, 0.5M 50cm Direct Attach Cable; 10G SFP+ for stacking
SFP+, Direct Attach, 1M 1m Direct Attach Cable; 10G SFP+ for stacking
SFP+, Direct Attach, 3M 3m Direct Attach Cable; 10G SFP+ for stacking
SFP+, Direct Attach, 5M 5m Direct Attach Cable; 10G SFP+ for stacking
SFP+, Direct Attach, 7M 7m Direct Attach Cable; 10G SFP+ for stacking
To Next Page
Loading...