Aruba S3500 Series Uplink Module - Removing Uplink Module; Installing an SFP; Removing an SFP

Aruba S3500 Series Uplink Module | Installation Guide 5
Removing Uplink Module
To remove an uplink module:
1. Remove any cables from the uplink module.
2. Remove any SFP modules attached to the uplink module.
3. Using a Phillips head screwdriver, loosen both screws on the front of the uplink module.
4. Lower the left screw as far as it can go.
5. Using the uplink module’s handle, pull the module out.
6. If you are not replacing the removed uplink module, install a blanking plate that was include with your
S3500.
Installing an SFP
To install an SFP module into tan S3500:
1. Slide the SFP module, top side facing upward, into a 1000Base-X port until a connection is made and an
audible click is heard.
2. Lock the SFP in place by moving the latch on the module to an upright position, facing the top of the
module.
Figure 3 Installing an SFP
Removing an SFP
To remove an SFP module:
1. Open and release the latch on the SFP module.
2. Pull and remove the module from the port.
For instructions of removing and SFP module, see "Removing an SFP" on page5.
Use standard ESD precautions when installing or removing an SFP.