What to do if my AS MOTOR AS 1000 OVIS RC Motorized Toy Car does not move?
If your AS MOTOR Motorized Toy Car does not move, check if the rotary knob limit speed is set to “0”. If so, adjust the rotary knob limit speed. Another possible reason is that the hydrostatic drive is overheated, in that case, allow it to cool down.
Why does my AS MOTOR AS 1000 OVIS RC engine get hot?
If your AS MOTOR Motorized Toy Car engine is getting too hot, it could be due to a dirty ventilation grid, so clean the ventilation grid. It could also be due to a low oil level in the engine, so refill the engine oil. Another reason could be dirty cooling fins, in which case you should have the cooling fins cleaned by an authorized service center.
Why is my AS MOTOR AS 1000 OVIS RC Motorized Toy Car engine smoking?
If the engine of your AS MOTOR Motorized Toy Car is smoking, it could be due to a dirty or oil-drenched air filter. Maintain or replace the air filter. Alternatively, the oil level might be too high, in which case you should have an authorized service center lower the oil level to the correct marking.
Why does my AS MOTOR Motorized Toy Car engine start badly or run irregularly?
If your AS MOTOR Motorized Toy Car's engine starts poorly or runs irregularly, there are several potential causes: * The choke may be closed; open it. * The air filter may be dirty; maintain it. * The fuel may be of poor quality, dirty, or old; use fresh fuel. * The spark plug may be dirty, damaged, or have an incorrect electrode gap; clean the spark plug and check the electrode gap, replacing it if necessary.
What should I do if my AS MOTOR AS 1000 OVIS RC starter does not turn?
If the starter on your AS MOTOR Motorized Toy Car isn't turning, it might be due to an emergency stop situation. Eliminate the emergency stop situation. Also, check the fuse and replace it if it's defective. Finally, the battery might be empty or defective; in that case, charge or replace the battery.
Why is there no connection between the transmitter and receiver on my AS MOTOR AS 1000 OVIS RC Motorized Toy Car?
A lack of connection between the transmitter and receiver on your AS MOTOR Motorized Toy Car can occur for several reasons: * The transmitter or device battery might be empty, so replace or charge the battery. * The radio range might be exceeded, so reduce the distance between the transmitter and receiver. * Radio interference from other transmitters might be present, so switch off and restart both devices after 10 seconds. * The emergency stop switch may be activated, so unlock it. * The antenna may be loose or damaged, so fasten or replace it. * Try switching the radio channel. * Increase the distance to or remove any disturbance sources.
Why can't I engage the blade on my AS MOTOR AS 1000 OVIS RC Motorized Toy Car?
General| Brand | AS MOTOR |
|---|---|
| Model | AS 1000 OVIS RC |
| Category | Motorized Toy Car |
| Language | English |
Describes device purpose, limitations, and support information.
Explains hazard levels, signal words, and device safety signs.
Details the information provided on the device's identification plate.
Covers user limits, fuel handling, first aid, and fire safety.
Details checks before use and operational risks.
Specifies PPE and clearing the mowing area.
Instructions for inclines and tipping hazards.
Instructions for stopping and cooling the device.
Safety advice for maintenance tasks.
Identifies and labels components on the main unit and remote control.
Explains main switch, choke, emergency stop, fuel valve, speed, and status.
Explains blade engagement and cutting height adjustment.
Lists all controls and their functions on the remote.
Describes device signals and built-in safety mechanisms.
Covers checks, fuel, and transmitter battery management.
How to check/replace transmitter batteries and set cutting height.
Step-by-step guide to power up and set radio frequency.
Steps to start the engine and initial practice procedures.
How to control direction, turning, and speed of travel.
How to set speed, operate on slopes, and engage the blade.
Procedures for stopping, parking, and using the emergency stop.
Steps for safely loading and unloading.
Routine checks for safety and security of components.
Overview of maintenance tasks and their frequencies.
Checking start-stop switch, hydrostatic drive, and battery.
Positioning for maintenance and cleaning key parts.
Testing RC functions and steering adjustments.
Verifying emergency stop, parking brake, and blade/shaft integrity.
Procedures for replacing flail blades and checking mountings.
Verifying blade brake clutch and chain tension.
Engine oil, air filter, and battery charging procedures.
Procedures for battery, hydrostat, and grease lubrication.
Guidelines for storing, ordering parts, and disposing of the device.
Diagnosing general faults and engine start problems.
Problems with engine running, noise, and cutting performance.
Problems with device movement, stopping, and chain detachment.
Explains error codes and radio communication problems.
Lists technical data like type, engine, dimensions, and sound levels.
Lists fuse positions, ratings, and their supplied components.
Lists optional accessories available for the device.
Declares compliance with relevant EC safety and health directives.
Describes different types of mowers and equipment offered.
To Next Page