Why is my AS MOTOR AS 510 ProClip vibrating so much?
A
Amanda IbarraAug 18, 2025
Strong vibrations during operation of your AS MOTOR Lawn Mower can be caused by several factors. An unbalance at the blade, due to incorrect sharpening or chips, can cause vibrations; have the blade balanced and re-sharpened by an authorised service centre, and replace a damaged blade immediately. If the blade drive shaft is bent, or the engine or blade fastening are loose, consult an authorised service centre.
K
Kenneth EricksonAug 21, 2025
Why is my AS MOTOR Lawn Mower engine smoking?
P
Paul AndrewsAug 21, 2025
If your AS MOTOR Lawn Mower engine is smoking, the air filter may be soiled or drenched with oil; in this case, clean or replace the air filter. Alternatively, the oil level might be too high, and you should have an authorised service centre lower the oil level to the correct marking.
R
Robert AvilaAug 25, 2025
What to do if my AS MOTOR AS 510 ProClip engine gets hot?
M
Michael VasquezAug 25, 2025
If the engine of your AS MOTOR Lawn Mower gets hot, the ventilation grid might be dirty; in this case, clean the ventilation grid. If the oil level in the engine is too low, refill the engine oil according to the engine manufacturer's operating instructions. If the cooling fins of the engine are dirty, have them cleaned by an authorised service centre.
C
Curtis MartinezAug 28, 2025
Why does my AS MOTOR AS 510 ProClip engine start badly?
M
Michael BartonAug 28, 2025
If your AS MOTOR Lawn Mower engine starts badly or runs irregularly, it could be due to a few reasons. The air filter might be soiled, so clean it. Always use fresh fuel, as poor quality, dirty, or old fuel can cause issues. Also, the spark plug could be sooted, damaged, or have an incorrect electrode gap; in this case, clean the spark plug and check the electrode gap, replacing it if necessary. If the housing of the mower is jammed, consult the Maintenance and Cleaning section.
S
Scott MurphyAug 31, 2025
How to fix uneven cut from AS MOTOR AS 510 ProClip Lawn Mower?
S
shannon29Aug 31, 2025
An uneven cut from your AS MOTOR Lawn Mower, resulting in an unsightly lawn, can occur if the blade is dull or worn. Have the blade balanced and re-sharpened, or replaced if damaged, by an authorised service centre. If the speed is too high for the cutting height, reduce the speed and/or select the correct cutting height. Lastly, a heavily soiled mower housing can cause this issue, so clean it.
C
Christine ChungSep 3, 2025
What causes the housing of AS MOTOR Lawn Mower to jam?
H
howeseanSep 3, 2025
If the housing of your AS MOTOR Lawn Mower is jammed, it may be because the mowed grass was too long or too damp. Adjust the cutting height and mowing speed to suit the mowing conditions. Alternatively, the blade may be worn, or the engine speed too low, in which case you should consult an authorised service centre.
K
Kevin CabreraSep 6, 2025
What to do if the blade slides on AS MOTOR Lawn Mower?
L
Lynn CarlsonSep 6, 2025
To address the issue of the blade sliding on your AS MOTOR Lawn Mower, replace the friction discs.
T
Todd HowardSep 10, 2025
What to do if AS MOTOR Lawn Mower engine does not switch off?
M
Mary BrownSep 10, 2025
If the engine of your AS MOTOR Lawn Mower does not switch off, the switching off system is likely defective. Close the fuel valve and consult an authorised service centre.
J
Joshua ThompsonNov 13, 2025
Why won't my AS MOTOR AS 510 ProClip Lawn Mower engine start?
L
Leah MccormickNov 13, 2025
If your AS MOTOR Lawn Mower engine won't start, there are several potential causes. Ensure the engine brake lever is pressed towards the handlebar. Check that the fuel valve and tank ventilation screw are open. Refill the fuel tank if it's empty. Make sure the choke is closed. If the device was tilted and the air filter is oily, replace the air filter, unscrew the spark plug, start the engine several times with the fuel valve closed, and then dry and replace the spark plug. If the engine was flooded, unscrew the spark plug, start the engine several times with the fuel valve closed, and then dry and replace the spark plug. Verify the spark plug connector is properly attached. Clean a soiled air filter. Clean or replace a sooted or damaged spark plug, ensuring the correct electrode gap. For ...
To Next Page
General
