EasyManua.ls Logo

AS MOTOR AS 730 EcoBrush - User Manual

AS MOTOR AS 730 EcoBrush
40 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
AS-Motor Germany GmbH & Co. KG
Ellwanger Straße 15 D-74424 Bühlertann
Internet: www.as-motor.de
E09800, E09810, E09875
Owners Manual Power Sweeper
Copyright © 2011 by AS-Motor Germany GmbH & Co. KG, Bühlertann Reproduction not permitted, neither in part nor in full. KR-332-025AB 10/2012-1
AS 730 EcoBrush/AS 830 EcoBrush
AS 830 H EcoBrush
EN- Translation of the Original Operating Instructions

Table of Contents

Questions and Answers

  • M
    mendozastacyAug 20, 2025
    How to fix AS MOTOR AS 730 EcoBrush Blower when motor will not start?
    • S
      Stacy TurnerAug 20, 2025
      If your AS MOTOR Blower's motor won't start, several factors could be at play. First, ensure the fuel tank isn't empty by filling it. If the motor is cold, the throttle lever should be set to choke. Check that the spark plug leads are securely connected. For Honda motors, verify that the fuel valve is open. If these steps don't work, the fuel line might be blocked, requiring professional cleaning, or the carburetor might be loose, needing the fixing screws to be tightened.
  • J
    Judith SuttonAug 22, 2025
    Why is my AS MOTOR AS 730 EcoBrush overheating?
    • M
      marklambertAug 22, 2025
      If the AS MOTOR Blower's motor is overheating, check the oil level and refill if it's too low. A soiled air filter can also cause overheating, so clean it. Additionally, the air cooling system might be restricted, and the carburetor may not be correctly adjusted, in which case you should send the air cooler grille and cooling ribs or the carburetor to a workshop for adjustment.
  • J
    Jerry MejiaAug 25, 2025
    What to do if AS MOTOR AS 730 EcoBrush motor is running badly and misfiring?
    • S
      Sharon GlennAug 25, 2025
      If your AS MOTOR Blower motor is running badly and misfiring, several things could be wrong. First, make sure the motor isn't running with the choke activated; if it is, allow the motor to cool and firmly connect the spark plug leads. A soiled air filter can also cause misfires, so clean it. Another potential cause is a blocked air bleed hole in the fuel tank filler cap, which would require replacing the cap. Finally, a blocked fuel line or an incorrectly adjusted carburetor could be the culprit, requiring professional cleaning or adjustment.
  • C
    cheryl39Aug 26, 2025
    Why my AS MOTOR AS 730 EcoBrush Blower motor has lost power?
    • S
      Stephen GonzalezAug 26, 2025
      If your AS MOTOR Blower has lost power, start by checking the air filter and clean it if it's soiled. If the air filter isn't the issue, the compression might be too low, requiring professional adjustment at a workshop.
  • S
    stephen92Aug 27, 2025
    Why does my AS MOTOR AS 730 EcoBrush Blower motor often stop during tickover?
    • P
      Pamela BenitezAug 28, 2025
      If your AS MOTOR Blower motor often stops during tickover, ensure the throttle lever is set to choke when the motor is cold. Also, a soiled air filter can cause this issue, so clean it. The spark plug gap may not be correct and the carburettor should be sent to workshop for adjustment.
  • A
    Adam TorresAug 30, 2025
    What causes AS MOTOR Blower motor to misfire at high speed?
    • L
      Lydia EspinozaAug 30, 2025
      If your AS MOTOR Blower motor misfires at high speed, the spark plug gap might not be correct, or the carburetor may not be correctly adjusted. In both cases, you should send the spark plugs or the carburetor to a workshop for adjustment.
  • R
    Ronald MitchellAug 31, 2025
    Why AS MOTOR AS 730 EcoBrush brushes have permanent squeaking?
    • D
      Dr. Marie Haney DDSSep 1, 2025
      If you're experiencing permanent squeaking from the brushes of your AS MOTOR Blower, ensure the switch lever is completely pressed down when switched on. If the squeaking persists, the Bowden cable may not be correctly adjusted, requiring readjustment.
  • J
    Jacqueline SmithSep 2, 2025
    What to do if AS MOTOR AS 730 EcoBrush brushes do not turn or stop moving?
    • L
      Lisa GlassSep 3, 2025
      If the brushes on your AS MOTOR Blower do not turn or stop moving, make sure the switch lever is completely pressed down under load. If that's not the issue, the Bowden cable might not be correctly adjusted and needs readjustment. A third possibility is that the toothed belts are defective, requiring replacement at a workshop.
  • G
    gcampbellSep 4, 2025
    Why AS MOTOR AS 730 EcoBrush movement drive does not work?
    • L
      linda21Sep 5, 2025
      If the movement drive on your AS MOTOR Blower isn't working, or the machine won't move forward, the Bowden cable may not be correctly adjusted; try readjusting it. Alternatively, the toothed belt tension between the motor and gearbox might be too low, requiring adjustment at a workshop.
  • Z
    zgatesSep 6, 2025
    What to do if AS MOTOR Blower motor will not start and there is petrol smell?
    • N
      norman75Sep 6, 2025
      If your AS MOTOR Blower motor won't start and there's a petrol smell, it could be receiving too much fuel. Try setting the throttle lever to full speed instead of choke. Also, the air filter might be soiled and need cleaning.

AS MOTOR AS 730 EcoBrush Specifications

General IconGeneral
BrandAS MOTOR
ModelAS 730 EcoBrush
CategoryBlower
LanguageEnglish